This work examines how the pollution from landfill aftercare effect the surrounding area and water basins. The subject of the study was a closed landfill where waste was disposed of without any accounting and operation of the landfill. During the study, soil, surface water, and sediment samples were taken over a two-year period. The data obtained compared with the maximum allowable concentrations established in the Northern part of Lithuania. The water sampling sites were selected taking into account the direction of the water flow, and the landfill was found to influence the water quality. Within 500 meters before the landfill, heavy metals and metalloid concentrations did not exceed the maximum allowable concentrations (Pb ≤ 20 µg/L; Ni ≤ 40 µg/L; Cr ≤ 100 µg/L; Cu ≤ 100 µg/L and As ≤ 20 µg/L). Soil and water sediment contamination factor and contamination level were determined for each metal and metalloid individually, which showed that as a single chemical element and its compounds none of them pose any danger to the environment. A different situation can be seen when calculating the total level of contamination, taking into account all pollutants classified as very hazardous, Z_d > 10. The results showed that monitoring (of surface water, including soil) and investigations, helping to reduce negative environmental impact, should be continued in the closed landfill.

The most important advances in sustainability in the water industry are focused on the reuse of water treatment sludge. The Antaviliai Water Supply Plant, which is located in Lithuania, treats groundwater by removing iron and manganese from it. This technology does not produce water waste, as the iron sludge is used for recycling. In this study, iron sludge received from groundwater treatment is used to remove natural organic matter from river Neris water, which can be used as drinking water. Twelve doses (from 1 to 6 g/L and from 0.1 g/L to 0.9 g/L) of iron sludge powder, with acid and without it, were used. The most effective removal of organic compounds (55.51%) and reduction in water colour (53.12%) were observed when 0.3 g of iron sludge powder and 8 ml of 0.95% H₂SO₄ solution were added to the tested water. It was found that the use of a conventional coagulant (Al₂(SO₄)₃*17H₂O), with and without iron sludge powder, decreased the concentration of organic compounds and water colour from 2.8 to 28.2% compared with the use of a pure coagulant (Al₂(SO₄)₃*17H₂O) alone..

The groundwater used as drinking water often contains unacceptable amounts of iron and manganese compounds and ammonium ions. These substances are efficiently removed using conventional technologies (aeration and filtration through granular media filters). However, the efficiency is drastically reduced for water containing considerable amounts of organic matter, which usually enters the water in wellfields linked with surface water. This paper presents a technology development for treating groundwater with such complex problems. A combination of open and closed aeration and filtering through three filters containing sand, zeolite and sand with oxidizing bacteria are used. Polyaluminium chloride acting as coagulant is the only chemical substance used in the technology. The developed water treatment technology was tested for eight months. The technology ensured the reduction of iron, manganese, ammonium, and organic compounds by 98%, 87%, 99%, and 80%, respectively. The efficiencies are sufficient to meet the requirements of the Council Directive 98/83/EC on the quality of water intended for human consumption for most wellfields fed by both underground and surface water.

Sapropel was used as a biodegradable material for water treatment. Sapropel is a sedimentary layer of a mix of organic and inorganic substances accumulated in the bottoms of lakes for thousands of years. It is a jelly-like homogeneous mass and has properties of sorption. Sapropel is used as a biosorbent and an environment-friendly fertiliser, and it is used in building materials and in the beauty industry as well. In water, there are abundant various solutes that may cause a risk to human health. Such substances include fluorides, nitrates and lead in different sources of water. The goal of this investigation is to explore and compare the efficiencies of removal of different pollutants (fluorides, nitrates and lead) from aqueous solutions upon using sapropel as a sorbent. In this research, various doses of sapropel (0.1, 0.5, 1, 5, 10, 20, 50, 100 and 200 g/L) and various mixing times (15, 30, 60, 90 and 120 min) were used for removal of fluorides, nitrates and lead from aqueous solutions. It was found that the maximum efficiency (up to 98.57%) of lead removal from aqueous solutions by sapropel was achieved when the minimum doses of it (0.1 and 0.5 g/L) were used. The most efficient removal of fluorides (64.67%) was achieved by using 200 g/L of sapropel and mixing for 120 min. However, sapropel does not adsorb nitrates from aqueous solutions.

Sapropel is a layer of sediment composed of organic and inorganic substances that accumulates at the bottom of lakes. The water of such lakes often have elevated levels of heavy metals such as Cd, Cr, Cu, and Zn, which can pose risks to human health. Sapropel may be used as a biosorbent in removing these heavy metals from aqueous solutions. Various doses of sapropel ranging from 1 to 50 g/L and different mixing times from15 to150 minutes have been tested. The maximum removal efficiencies for Cd (93%), Cr (31%), Cu (84%), and Zn (84%) from aqueous solutions were achieved using the minimum doses of sapropel (50 g/L). The study has shown that mixing sapropel for 15 minutes is sufficient for the removal of Cr, 30 minutes for Cd and Cu, and 60 minutes for Zn.

Research on the Efficiency of Filter Media