There is an urgent need for the development of alternative strategies for effective drug delivery to improve the outcome of patients suffering from deadly diseases such as cancer. Nanoparticles, in particular layered double hydroxide (LDH) nanoparticles, have great potential as nanocarriers of chemotherapeutic molecules. In this study, we synthesized (Zn, Al)-LDH nanoparticles and report their enhanced pH-dependent stability in comparison to the commonly used (Mg, Al)-LDH nanoparticles. Fluorescein isothiocyanate (FITC) and valproate (VP) were intercalated into (Zn, Al)-LDH nanoparticles to study cellular uptake, biocompatibility, and drug delivery capabilities using cultured pancreatic adenocarcinoma BxPC3 cells. Fluorescence measurements indicated that FITC-intercalated LDH nanoparticles showed a greater degree of energy-dependent uptake rather than passive uptake by BxPC3 cells, especially at high concentrations of nanoparticles. Tetrazolium-based colorimetric assays indicated that BxPC3 cells treated with VP-intercalated LDH nanoparticles showed a significant reduction in cell viability along with about 30-fold reduction in IC50compared to the drug alone. In contrast, the non-drug-intercalated LDH nanoparticles did not affect the cell viability indicating very low innate cytotoxicity. Our research indicates that the superior properties of (Zn, Al)-LDH nanoparticles make them ideal candidates for further development asin vivochemotherapy drug delivery agents.
2 July 2018 in IEEE Transactions on Electron Devices
Autonomous smart windows may be integrated with a stack of active components, such as electrochromic devices, to modulate the opacity/transparency by an applied voltage. This voltage may be generated with a visibly transparent photovoltaic device. This paper describes the processing and performance of zinc oxide (ZnO) films for integration with electrochromic stacks. Sputtered ZnO (2% Mn) films on indium-tin oxide with transparency in the visible range were used to fabricate metal- semiconductor (MS), metal-insulator-semiconductor, and p-i-n heterojunction devices, and their photovoltaic conversion under ultraviolet (UV) illumination was evaluated with and without oxygen plasma-treated surface electrodes (Au, Ag, Al, and Ti/Ag). The MS Schottky parameters were fit against the generalized Bardeen model to obtain the density of interface states (D it ≈ 8.0 × 10 11 eV -1 cm -2 ) and neutral level (E o ≈ -5.2 eV). These devices have exhibited a photoconductive behavior at λ = 365 nm, and low-noise Ag-ZnO detectors have exhibited the responsivity (R) and photoconductivegain (G) of 1.93×10 -4 A/W and 6.57×10 -4 , respectively. Confirmed via matched-pair analysis, postmetallization oxygen plasma treatment of Ag and Ti/Ag electrodes has resulted in increased Schottky barrier heights, which maximized with a 2-nm SiO 2 electron blocking layer, coupled with the suppression of recombination at the MS interface and blocking of majority carriers. For interdigitated devices under monochromatic UV-C illumination, the open-circuit voltage (V oc ) was 1.2 V and short-circuit current density (J sc ), due to minority carrier tunneling, was 0.68 mA/cm 2 .
1 September 2006 in Journal of Vacuum Science & Technology B: Microelectronics and Nanometer Structures Processing, Measurement, and Phenomena
films were deposited by plasma-enhanced atomic layer deposition (PEALD) and thermal ALD on native oxide surface . The properties of as-deposited and forming gas annealed films were examined and qualitatively compared with respect to nanostructural, nanochemical, capacitance-voltage and leakage-current–voltage , and oxide breakdown characteristics. Although high-resolution transmission electron microscopy showed structurally sharp interfaces in forming gas annealed PEALD stacks, electron energy loss spectroscopy revealed interdiffusion of Ta and Si across this interface, the indiffusion length of Ta being higher than the outdiffusion length of Si. The consequent formation and enhancement of Ta–O–Si bond linkages in thicker films were clearly reflected in the data. Moreover, the fixed charge density was thickness invariant in PEALD . For similar PEALD and ALD thickness in stacks, the latter showed a lower and higher defect density, results attributed to protons and hydroxyl groups, respectively, which stem from water used as an oxidant for the thermal ALD process.