The use of radar information for collision avoidance is common, however it is effective only for constant values of ship motion parameters. As information delays or information errors occur, it is reasonable to supplement the information derived from radar with another information system. An ideal system should operate automatically and continuously. A system that appears to be suitable to provide this kind of information is the Automatic Identification System (AIS), which may be classified as a radio communication system that uses radio waves to transmit data with regard to ship motion parameters. In this paper the topic of integrity and completeness of AIS information is discussed and the research results for the completeness and integrity of dynamic information are presented. In addition, the outcomes of AIS information correctness from the Gulf of Gdańsk were compared with studies carried out in the Baltic Sea, east of Bornholm, between Trelleborg and Arkona. The results of research for AIS dynamic information with the highest completeness (Position, Course over Ground and Speed over Ground) are presented. The research outcomes presented in the paper lead to the conclusion that AIS could deliver useful supplementary information in the process of collision avoidance.

To enhance the safety of marine navigation, one needs to consider the involvement of the automatic identification system (AIS), an existing system designed for ship-to-ship and ship-to-shore communication. Previous research on the quality of AIS parameters revealed problems that the system experiences with sensor data exchange. In coastal areas, littoral AIS does not meet the expectations of operational continuity and system availability, and there are areas not covered by the system. Therefore, in this study, process models were designed to simulate the tracking of vessel trajectories, enabling system failure detection based on integrity monitoring. Three methods for system integrity monitoring, through hypotheses testing with regard to differences between model output and actual simulated vessel positions, were implemented, i.e., a Global Positioning System (GPS) ship position model, Dead Reckoning and RADAR Extended Kalman Filter (EKF)—Simultaneous localization and mapping (SLAM) based on distance and bearing to navigational aid. The designed process models were validated on simulated AIS dynamic data, i.e., in a simulated experiment in the area of Gdańsk Bay. The integrity of AIS information was determined using stochastic methods based on Markov chains. The research outcomes confirmed the usefulness of the proposed methods. The results of the research prove the high level (~99%) of integrity of the dynamic information of the AIS system for Dead Reckoning and the GPS process model, while the level of accuracy and integrity of the position varied depending on the distance to the navigation aid for the RADAR EKF-SLAM process model.

Due to the safety reason, the ship movement on the littoral area should be monitored, tracked, recorded and stored. Automatic Identification System (AIS) is the perfect tool to ensure this requirement. The limit probability for the AIS dynamic data availability can be limited by the lack of Global Position System (GPS) signal, heading (HDG) and rate of turn (ROT) data in position report. Availability of data link is an additional limitation. For this purpose, it is possible to attach the Discrete Kalman filter (KF) for the position, and course estimation. Coordinate estimation in the absence of a transmission link can improve the quality of AIS service at Vessel Traffic Service (VTS) stations. This article presents Kalman filtering algorithm to improve the possibilities of ship motion tracking and monitoring in the TSS (Traffic Separation Scheme) and fairways area. Only 39 iterations were presented to familiarize how the Kalman filter algorithm works. The archival data from 2006 were used deliberately. During that time, there were problems with the AIS availability service. With the use of measurements series from those years, it is easier to observe the effectiveness of Kalman filter in absence of AIS data.

This article covers research on an innovative propulsion system design for a Biomimetic Unmanned Underwater Vehicle (BUUV) operating at low speeds. The experiment was conducted on a laboratory test water tunnel equipped with specialised sensor equipment to assess the Fluid-Structure Interaction (FSI) and energy consumption of two different types of propulsion systems. The experimental data contrast the undulating with the drag-based propulsion system. The additional joint in the drag-based propulsion system is intended to increase thrust and decrease energy input. The tests were conducted at a variety of fins oscillation frequencies and fluid velocities. The experiments demonstrate that, in the region of low-speed forward movement, the efficiency of the propulsion system with the additional joint is greater.

The aim of the presented research was to analyze the accuracy indications of three types of compass systems for the purposes of meeting warship modernization requirements. The authors of this paper have made an attempt to compare the accuracy of an onboard standard gyrocompass, a fiber-optic gyrocompass (FOG) and a satellite compass in real shipping circumstances. The research was carried out in the Gulf of Gdansk area, during the preparation of hydrographic surveys on stable courses. Three heading recordings have been taken into consideration. The helmsman’s operation and vessel inertia were analyzed and removed according to a spectrum analysis. Transient characteristics and the spectrum analysis (based on the Fourier transform theory and headings descriptions in the frequency domain) are presented. Data, processed using a band-stop finite impulse response (FIR) filter to reduce low-frequency heading distortions, are presented for further analyses. The statistics of errors of the compasses investigated, as well as the spectrum of these errors, are also presented. Based on accuracy measurements, the possibility of using the most accurate heading data as the input signal to the automatic ship control system was considered.