Matthew Asmussen

Dr. Matthew Asmussen

orcid

Research Focus & Metrics

Academic Career Length

11Years (2016-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
23 December 2022 in Frontiers in Chemistry
Verified
Journal Article
Open access
MAMatthew Asmussen
Matthew Asmussen
JTJoshua Turner
Joshua Turner
SCSaehwa Chong
Saehwa Chong
BRBrian J. Riley
Brian J. Riley
Radioiodine capture and immobilization is not only important to consider during the operation of reactors (i.e., I-131), during nuclear accidents (i.e., I-131 and I-129) or nuclear fuel reprocessing (i.e., I-131 and I-129), but also during disposal of nuclear wastes (i.e., I-129). Most disposal plans for I-129-containing waste forms (including spent nuclear fuel) propose to store them in underground repositories. Here, iodine can be highly mobile and, given its radiotoxicity, needs to be carefully managed to minimize long-term environmental impacts arising from disposal. Typically, any process that has been used to capture iodine from reprocessing or in a reactor is not suitable for direct disposal, rather conversion into a wasteform for disposal is required. The objectives of these materials are to use either chemical immobilization or physical encapsulation to reduce the leaching of iodine by groundwaters. Some of the more recent ideas have been to design capture materials that better align with disposal concepts, making the industrial processing requirements easier. Research on iodine capture materials and wasteforms has been extensive. This review will act as both an update on the state of the research since the last time it was comprehensively summarized, and an evaluation of the industrial techniques required to create the proposed iodine wasteforms in terms of resulting material chemistry and applicability.

8 May 2018 in ACS Earth and Space Chemistry
Verified
Journal Article
Closed access
CPCarolyn Pearce
Carolyn Pearce
JIJonathan P. Icenhower
Jonathan P. Icenhower
MAMatthew Asmussen
Matthew Asmussen
PTPaul G. Tratnyek
Paul G. Tratnyek
KRKevin M. Rosso
Kevin M. Rosso
NQNikolla P. Qafoku
Nikolla P. Qafoku

26 February 2019 in Materials
Verified
Journal Article
Open access
PDF file
MAMatthew Asmussen
Matthew Asmussen
JRJoseph V. Ryan
Joseph V. Ryan
JMJosef Matyas
Josef Matyas
JCJarrod V. Crum
Jarrod V. Crum
JRJoelle T. Reiser
Joelle T. Reiser
NCNathan Canfield
Nathan Canfield
To prevent the release of radioiodine during the reprocessing of used nuclear fuel or in the management of other wastes, many technologies have been developed for iodine capture. The capture is only part of the challenge as a durable waste form is required to ensure safe disposal of the radioiodine. This work presents the first durability studies in dilute conditions of two AgI-containing waste forms: hot-isostatically pressed silver mordenite (AgZ) and spark plasma sintered silver-functionalized silica aerogel (SFA) iodine waste forms (IWF). Using the single-pass flow-through (SPFT) test method, the dissolution rates respective to Si, Al, Ag and I were measured for variants of the IWFs. By combining solution and solid analysis information on the corrosion mechanism neutral-to-alkaline conditions was elucidated. The AgZ samples were observed to have corrosion preferentially occur at secondary phases with higher Al and alkali content. These phases contained a lower proportion of I compared with the matrix. The SFA samples experienced a higher extent of corrosion at Si-rich particles, but an increased addition of Si to the waste led to an improvement in corrosion resistance. The dissolution rates for the IWF types are of similar magnitude to other Si-based waste form materials measured using SPFT.

10 August 2016 in Radiochimica Acta
Verified
Journal Article
Closed access
PDF file
MAMatthew Asmussen
Matthew Asmussen
JNJames J. Neeway
James J. Neeway
ALAmanda Lawter
Amanda Lawter
AWAndrew Wilson
Andrew Wilson
NQNikolla P. Qafoku
Nikolla P. Qafoku
A prominent radionuclide of concern in nuclear wastes, 129I, is present in low-activity wastes (LAW) at the Hanford site. Several Ag-containing materials were tested as immobilization agents, or “getters”, for I (as iodide, I−) removal from deionized (DI) water and a liquid LAW simulant: Ag impregnated activate carbon (Ag–C), Ag exchanged zeolite (Ag–Z), and argentite. In anoxic batch experiments with DI water, the Ag–C and argentite were most effective, with maximum Kd values of 6.2 × 105 mL/g for the Ag–C and 3.7 × 105 mL/g for the argentite after 15 days. Surface area and Ag content were found to influence the performance of the getters in DI water. In the anoxic batch experiments with LAW simulant, Ag–Z vastly outperformed the other getters with Kd values of 2.2 × 104 mL/g at 2 h, which held steady until 15 days, compared with 1.8 × 103 mL/g reached at 15 days by the argentite. All getters were stable over long periods of time (i.e. 40 days) in DI water, while the Ag–Z and argentite were also stable in the LAW simulant. Ag–Z was found to have consistent I removal upon crushing to a smaller particle size and in the presence of O2, making it a strong candidate for the treatment of LAW containing I.

1 November 2018 in Journal of Nuclear Materials
Verified
Journal Article
Closed access
JPJacob A. Peterson
Jacob A. Peterson
JCJarrod V. Crum
Jarrod V. Crum
BRBrian J. Riley
Brian J. Riley
MAMatthew Asmussen
Matthew Asmussen
JNJames J. Neeway
James J. Neeway

1 March 2019 in Journal of Nuclear Materials
Verified
Journal Article
Closed access
JNJames J. Neeway
James J. Neeway
MAMatthew Asmussen
Matthew Asmussen
EMErin M. McElroy
Erin M. McElroy
JPJacob A. Peterson
Jacob A. Peterson
BRBrian J. Riley
Brian J. Riley
JCJarrod V. Crum
Jarrod V. Crum