This study focused on the mechanical and metallurgical characteristics of high-wear-resistance steel (HWS) deposited using directed energy deposition (DED) for metal substrate hardfacing or repairing. As post-deposition heat treatment changes the metallurgical characteristics of deposits, the effect of post-deposition heat treatment on the mechanical properties was investigated via microstructure observation and by conducting hardness, wear, and impact tests. The obtained micro-images showed that the deposited HWS layers exhibit cellular and columnar dendrites, and the microstructure of heat-treated HWS (HT-HWS) transformed its phase during quenching and tempering. The hardness and wear resistance of the HT-HWS deposits were higher than those of the HWS deposited specimen, whereas the latter exhibited a higher fracture toughness. The matrix microstructure and carbide characteristics, which are characterized by the chemical composition of the materials, significantly influenced the mechanical properties.
Currently, high-speed steel (HSS) powders are deposited locally on a metal surface through direct energy deposition (DED) onto hardface tool steel. Although the HSS powder enhances the hardness and the abrasion resistance of a metal surface, it makes the tool steel brittle because of its high carbon content. In addition, the steel is likely to break when subjected to a high load over time. This study focused on improving the steel toughness by applying a post-heat treatment. To fabricate a uniformly deposited layer through DED, M4 powder was deposited onto a pre-heated substrate (AISI D2). In addition, four post-heat-treated specimens were prepared, and their mechanical properties were compared. The Charpy impact and hardness tests were conducted to evaluate the durability required for the D2 die. The deposited M4 powder possessed a high hardness but a relatively low impact toughness. During laser melting, a stable bond formed between M4 and D2 without any cracks or delamination. The hardness of the initial M4 deposited layer was 63 HRC, which changed to 54–63 HRC depending on the effect of the post-heat treatment. Moreover, the post-heat-treatment process improves the impact toughness of the M4 deposited layer by changing its microstructure.
High thermal conductivity steel (HTCS-150) is deposited onto non-heat-treated AISI H13 (N-H13) via powder-fed direct energy deposition (DED) based on the response surface methodology (RSM) to enhance the mechanical properties and thermal conductivity of N-H13, which is generally used as a hot-work tool steel. The main process parameters of the powder-fed DED are priorly optimized to minimize defects in the deposited regions and, therefore, to obtain homogeneous material properties. The deposited HTCS-150 is comprehensively evaluated through hardness, tensile, and wear tests at the different temperatures of 25, 200, 400, 600, and 800 °C. Compared to conventionally heat-treated (quenched and tempered) H13 (HT-H13), the hardness of the additively manufactured HTCS-150 slightly increases at 25 °C, whereas it does not show any significant difference above 200 °C. However, the HTCS-150 deposited on N-H13 shows a lower ultimate tensile strength and elongation than HT-H13 at all tested temperatures, and the deposition of the HTCS-150 on N-H13 enhances the ultimate tensile strength of N-H13. While the HTCS-150 does not show a significant difference in the wear rate below 400 °C compared to HT-H13, it shows a lower wear rate above 600 °C. The HTCS-150 reveals a higher thermal conductivity than the HT-H13 below 600 °C, whereas the behavior is reversed at 800 °C. The results suggest that the HTCS-150 additively manufactured via powder-fed direct energy deposition can enhance the mechanical and thermal properties of N-H13, including hardness, tensile strength, wear resistance, and thermal conductivity in a wide range of temperatures, often superior to those of HT-H13.
5 June 2018 in Korean Journal of Metals and Materials