Stefan Schoder

Mr. Stefan Schoder

orcid

Research Focus & Metrics

Academic Career Length

10Years (2017-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
14 October 2020 in Acta Acustica
Verified
Journal Article
Open access
PDF file
SSStefan Schoder
Stefan Schoder
CJClemens Junger
Clemens Junger
MKManfred Kaltenbacher
Manfred Kaltenbacher
This contribution benchmarks the aeroacoustic workflow of the perturbed convective wave equation and the Ffowcs Williams and Hawkings analogy in Farassat’s 1A version for a low-pressure axial fan. Thereby, we focus on the turbulence modeling of the flow simulation and mesh convergence concerning the complete aeroacoustic workflow. During the validation, good agreement has been found with the efficiency, the wall pressure sensor signals, and the mean velocity profiles in the duct. The analysis of the source term structures shows a strong correlation to the sound pressure spectrum. Finally, both acoustic sound propagation models are compared to the measured sound field data.

1 February 2020 in The Journal of the Acoustical Society of America
Verified
Journal Article
Open access
PDF file
SSStefan Schoder
Stefan Schoder
MWMichael Weitz
Michael Weitz
PMPaul Maurerlehner
Paul Maurerlehner
AHAlexander Hauser
Alexander Hauser
SFSebastian Falk
Sebastian Falk
MKManfred Kaltenbacher
Manfred Kaltenbacher
A hybrid aeroacoustic approach was developed for the efficient numerical computation of human phonation. In the first step, an incompressible flow simulation on a three-dimensional (3 D) computational grid, which is capable of resolving all relevant turbulent scales, is performed using STARCCM+ and finite volume method. In the second step, the acoustic source terms on the flow grid are computed and a conservative interpolation to the acoustic grid is performed. Finally, the perturbed convective wave equation is solved to obtain the acoustic field in 3 D with the finite element solver CFS++. Thereby, the conservative transformation of the acoustic sources from the flow grid to the acoustic grid is a key step to allow coarse acoustic grids without reducing accuracy. For this transformation, two different interpolation strategies are compared and grid convergence is assessed. Overall, 16 simulation setups are compared. The initial (267 000 degrees of freedom) and the optimized (21 265 degrees of freedom) simulation setup were validated by measurements of a synthetic larynx model. To conclude, the total computational time of the acoustic simulation is reduced by 95% compared to the initial simulation setup without a significant reduction of accuracy, being 7%, in the frequency range of interest.

24 February 2021 in Journal of Theoretical and Computational Acoustics
Verified
Journal Article
Closed access
PDF file
SSStefan Schoder
Stefan Schoder
AWAndreas Wurzinger
Andreas Wurzinger
CJClemens Junger
Clemens Junger
MWMichael Weitz
Michael Weitz
CFClemens Freidhager
Clemens Freidhager
MKManfred Kaltenbacher
Manfred Kaltenbacher

15 March 2021 in Applied Sciences
Verified
Journal Article
Open access
PDF file
SSStefan Schoder
Stefan Schoder
PMPaul Maurerlehner
Paul Maurerlehner
AWAndreas Wurzinger
Andreas Wurzinger
AHAlexander Hauser
Alexander Hauser
SFSebastian Falk
Sebastian Falk
MKManfred Kaltenbacher
Manfred Kaltenbacher
The flow-induced sound sources of human voice production are investigated based on a validated voice model. This analysis is performed using a hybrid aeroacoustic workflow based on the perturbed convective wave equation. In the first step, the validated 3D incompressible turbulent flow simulation is computed by the finite volume method using STARCCM+. In a second step, the aeroacoustic sources are evaluated and studied in detail. The formulation of the sound sources is compared to the simplification (neglecting the convective sources) systematically using time-domain and Fourier-space analysis. Additionally, the wave equation is solved with the finite element solver openCFS to obtain the 3D sound field in the acoustic far-field. During the detailed effect analysis, the far-field sound spectra are compared quantitatively, and the flow-induced sound sources are visualized within the larynx. In this contribution, it is shown that the convective part of the sources dominates locally near the vocal folds (VFs) while the local time derivative of the incompressible pressure is distributed in the whole supra-glottal area. Although the maximum amplitude of the time derivative is lower, the integral contribution dominates the sound spectrum. As a by-product of the detailed perturbed convective wave equation source study, we show that the convective source term can be neglected since it only reduces the validation error by 0.6%. Neglecting the convective part reduces the algorithmic complexity of the aeroacoustic source computation of the perturbed convective wave equation and the stored flow data. From the source visualization, we learned how the VF motion transforms into specific characteristics of the aeroacoustic sources. We found that if the VFs are fully closing, the aeroacoustic source terms yield the highest dynamical range. If the VFs are not fully closing, VFs motion does not provide as much source energy to the flow-induced sound sources as in the case of a healthy voice. As a consequence of not fully closing VFs, the cyclic pulsating velocity jet is not cut off entirely and therefore turbulent structures are permanently present inside the supraglottal region. These turbulent structures increase the broadband component of the voice signal, which supports research results of previous studies regarding glottis closure and insufficient voice production.

23 February 2021 in Applied Sciences
Verified
Journal Article
Open access
PDF file
MLMartin Lasota
Martin Lasota
PŠPetr Šidlof
Petr Šidlof
MKManfred Kaltenbacher
Manfred Kaltenbacher
SSStefan Schoder
Stefan Schoder
In an aeroacoustic simulation of human voice production, the effect of the sub-grid scale (SGS) model on the acoustic spectrum was investigated. In the first step, incompressible airflow in a 3D model of larynx with vocal folds undergoing prescribed two-degree-of-freedom oscillation was simulated by laminar and Large-Eddy Simulations (LES), using the One-Equation and Wall-Adaptive Local-Eddy (WALE) SGS models. Second, the aeroacoustic sources and the sound propagation in a domain composed of the larynx and vocal tract were computed by the Perturbed Convective Wave Equation (PCWE) for vowels [u:] and [i:]. The results show that the SGS model has a significant impact not only on the flow field, but also on the spectrum of the sound sampled 1 cm downstream of the lips. With the WALE model, which is known to handle the near-wall and high-shear regions more precisely, the simulations predict significantly higher peak volumetric flow rates of air than those of the One-Equation model, only slightly lower than the laminar simulation. The usage of the WALE SGS model also results in higher sound pressure levels of the higher harmonic frequencies.

14 October 2022 in Acta Acustica
Verified
Journal Article
Open access
PDF file
PMPaul Maurerlehner
Paul Maurerlehner
SSStefan Schoder
Stefan Schoder
JTJohannes Tieber
Johannes Tieber
CFClemens Freidhager
Clemens Freidhager
HSHelfried Steiner
Helfried Steiner
MKManfred Kaltenbacher
Manfred Kaltenbacher
The hybrid aeroacoustic approach is an efficient way to address the issue of the disparity of scales in Computational AeroAcoustics (CAA) at low Mach numbers. In the present paper, three wave equations governing propagation of flow-induced sound of low Mach number flows, namely the Perturbed Convective Wave Equation (PCWE), Ribner’s Dilatation (RIB) equation, and Lighthill’s wave equation, are applied using the Finite Element Method (FEM). An airflow through a circular pipe with a half-moon-shaped orifice at three operating flow speeds is considered, where validation data from measurements on a dedicated test rig is available. An extensive analysis of the flow field is provided based on the results of the incompressible flow simulation. The resulting acoustic source terms are investigated, and the relevant source term contributions are determined. The results of the acoustic propagation simulations revealed that the PCWE and RIB are best suited for the present task. The overall deviation of the predicted pressure spectra from the measured mean values amounted to 2.26 and 2.13 times the standard deviation of the measurement compared to 3.55 for Lighthill’s wave equation. Besides reliably predicting the flow-induced sound, the numerical procedure of source term computation is straightforward for PCWE and RIB, where the source term contributions, shown to be relevant, solely consist of time derivatives of the incompressible pressure. In contrast, the Lighthill source term involves spatial derivatives and, thus, is strongly dependent on the spatial resolution and the numerical method actually used for approximating these terms.