Supercell thunderstorms can form extremely dangerous and destructive tornadoes. While high fidelity supercell simulations have increased the understanding of supercell mechanics to help determine how and when tornadoes form, there is a lack of targeted, in situ measurements taken aboveground in supercells to validate these simulations. Pseudo-Lagrangian drifters (PLDs) are atmospheric probes that can be used to attain thermodynamic measurements in areas that are difficult or dangerous to access, such as from within supercells. Of particular interest in understanding tornadogenesis is the rear-flank downdraft (RFD). However, strong outflow winds behind the rear-flank gust front (RFGF) make the RFD particularly difficult to access with balloon-borne sensors launched from the ground. A specific type of PLD, an air-launched drifter (ALD) that is released from unmanned aircraft systems (UAS), can be used to access RFD inflows, present at higher altitudes. Results from initial tests of ALDs are shown, along with results from a ground-released PLD test during a supercell intercept in the Oklahoma Panhandle on 12 June 2018. In characterization tests performed at the 2018 International Society for Atmospheric Research using Remotely piloted Aircraft (ISARRA) flight week, it was found that the ALD sensor system performs reasonably well against industry standards. However, improvements will be made to increase the aspiration of the sensor.
Metallic thermocouples are widely used for heat flux measurements in hypersonic ground and flight tests. If their materials differ from the surrounding surface, they introduce local discontinuities in surface properties. This work examines how such variations in material catalycity impact surface heat flux for hypersonic flows. A partially catalytic boundary condition is implemented in a hypersonic CFD solver, enabling species- and material-specific recombination at the wall. Analysis is performed for Mach 7 hypersonic airflow over a cylinder for which heat flux has been measured using thermocouples. Parametric studies demonstrate that for this flow condition, heat flux is highly sensitive to the oxygen recombination coefficient and minimally affected by nitrogen recombination. To directly emulate the experiments, simulations incorporate discrete segments of the thermocouple material (constantan) on the stainless steel surface of the cylinder. These analyses reveal localized heat flux overshoots and undershoots at material interfaces that arise from species transport and surface reaction coupling. Such effects are consistent with the experimental measurements and indicate that thermocouple materials can significantly perturb the local heat flux where measurements are taken. The results highlight the importance of accurately capturing wall material heterogeneity in both modeling and experimental interpretation of high-enthalpy flows.