This study is concerned with the need for remote sensing techniques for the monitoring of oil-slick pollution on sea surfaces and the effects of oil-slick pollution on the sea. We used Daqing crude oil, Jilin crude oil, heavy oil and seawater from Dalian Bay to simulate oil-slick pollution on the sea surface and obtained multi-angle hyperspectral polarized reflectance information, from which we calculated the polarization for different kinds of crude oil, and oil-slicks of different thicknesses. By comparing the degree of polarization between oil-slicks of different thickness, and sea water, it was found that in the case of thin oil-slicks, the degree of polarization of seawater is higher than that of oil slicks with wavelengths of between 400–1000 nm. However, there was little difference at a wavelength of 785 nm. At angles of incident of 20° and 30° (the viewing angle equals the incident angle), it was easy to distinguish the changes of oil-slick thickness by the degree of polarization at 785 and 880 nm in the near-infrared band. The crude oil showed its inherent polarized characteristic as the oil-slick thickness increased to a certain degree. That is to say, the polarization of the seawater was higher than that of the oil-slick in the visible light range, but less than that in the near-infrared band. As the incident angle changed from 40° to 50°, the degree of polarization of seawater increased, and it was higher than that for the oil-sick between wavelengths of 400–1000 nm at an angle of incidence of 50°. This research on the polarized characteristics of an oil-slick on a sea surface brings new scientific techniques to the monitoring of sea-surface pollution by remote sensing.
The bidirectional reflectance factor (BRF) is commonly used to study the structure of a particulate surface based on photometric measurements. In this paper, we describe the bidirectional reflectance factor distribution of natural particulate surfaces with particles sizes varying from 0.15 mm to 0.9 mm. Two types of natural particulate surfaces (one with low reflectance and the other with moderate reflectance) were measured at visible and near-infrared wavelengths using the Northeast Normal University Laboratory Goniospectrometer System (NENULGS). Both the BRFs and anisotropic reflectance factors (ARFs) at selected wavelengths were compared with previously published results to verify the accuracy of our measurements, and we also quantitatively analyzed the effects of particle size on the BRF. It was found that the maximum reflectance difference, which was more distinct for the low-reflectance samples, between particulate surfaces with particle sizes of 0.15 mm and 0.9 mm occurred in the forward scattering direction for all samples, and the value of this maximum difference reached 59% for the low-reflectance samples. Then, we conducted a test of a photometric model to determine which parameters could be confidently linked to the surfaces’ reflectance behavior. The inverted parameters were compared with the known physical parameters of our samples, such as the particle size. We found that the single-scattering albedo could be empirically used to determine the particle sizes of our samples when measurements of particulate surfaces with different particle sizes were performed under the same incidence conditions and with wide viewing angles. The potential applications of our results appear very promising for empirically resolving the spatial distribution of particle size within a given particulate sample as well as for deepening our understanding of the scattering properties of particulate media.
25 January 2019 in IEEE Transactions on Geoscience and Remote Sensing