A selective aqueous corrosion strategy was proposed for synthesizing low-dimensional nanometals through the dealloying of aqueous-favoring metals from their bulk alloys.
A comparative study was conducted to reveal the effect of microstructure on hydrogen permeation in the EA4T and 30CrNiMoV12 railway axle steels. Unlike the EA4T with its sorbite structure, 30CrNiMoV12 steel shows a typical tempered martensitic structure, in which a large number of fine, short, rod-like, and spherical carbides are uniformly dispersed at boundaries and inside laths. More importantly, this structure possesses plentifully strong hydrogen traps, such as nanosized Cr7C3, Mo2C, VC, and V4C3, thus resulting in a high density of trapping sites (N = 1.17 × 1022 cm−3). The hydrogen permeation experiments further demonstrated that, compared to EA4T, the 30CrNiMoV12 steel not only delivered minimally effective hydrogen diffusivity but also had a high hydrogen concentration. The activation energy for hydrogen diffusion of the 30CrNiMoV12 steel was greatly increased from 23.27 ± 1.94 of EA4T to 47.82 ± 2.14 kJ mol−1.
Realizing rapid and stable hydrogen sorption at low temperature is critical for magnesium-based hydrogen storage materials. Herein, liquid channels are built in magnesium hydride by introducing lithium borohydride ion conductors as an efficient route for improving its hydrogen sorption. For instance, the 5 wt% LiBH4-doped MgH2 can release about 7.1 wt.% H2 within 40 min at 300 °C but pure MgH2 only desorbs less than 0.7 wt.% H2, and more importantly it delivers faster desorption kinetics with more than 10 times enhancement to pure MgH2. The hydrogen absorption capacity of LiBH4-doped MgH2 can still be well kept at approximately 7.2 wt.% without obvious capacity degradation even after six absorption and desorption cycles. This approach is not only through building ion transfer channels as a hydrogen carrier for kinetic enhancement but also by inhibiting the agglomeration of MgH2 particles to obtain stable cyclic performance, which brings further insights to promoting the hydrogen ab-/desorption of other metal hydrides.
In this work, hydrogen segregation and damage sites in 1.2 GPa and 1.8 GPa grade hot-stamped steels were comparatively investigated by hydrogen permeation experiments and the hydrogen microprint technique (HMT). Compared with 1.2 GPa steel, 1.8 GPa steel exhibited a lower hydrogen diffusion coefficient (Deff) and a higher number of hydrogen trapping sites (Nt) due to its finer microstructure and richer nano-sized precipitates. The results of HMT showed that the grain boundaries in both steels played a role in initial hydrogen segregation, and then the martensitic laths became the locations of hydrogen accumulation. For 1.2 GPa and 1.8 GPa steels, however, hydrogen accumulation appeared preferentially on martensitic laths and grain boundaries, respectively, resulting in various damage behaviors. The introduced nano-sized carbides as “good hydrogen traps” played an important role in hydrogen diffusion, accumulation, and damage, which greatly alleviated hydrogen-induced cracking for the 1.8 GPa steel. Moreover, electron backscatter diffraction (EBSD) analysis further revealed that the damage behavior was also controlled by the low-angle grain boundary, stress distribution, and recrystallization fraction of the samples.