This paper develops a new method for the calculation of low speed characteristic of compressor. Considering of the compressibility of the air, the low speed index of pump machinery similarity theory is improved. A new index calculation method is proposed, and the correction factor is added in the modified theoretical formula to increase the calculation accuracy of the compressor characteristics. Genetic algorithm is adopted to realize the optimization of the calculation to obtain the best value of the correction factor. It does not need to consider the structure and thermodynamic parameters of the compressor, and calculates the low speed characteristics of the compressor based on the existing characteristic curves. The calculation results show that the characteristic curves solved by the method are reasonable in changing trends.
Considering the pressure gain characteristic of continuously rotating detonation (CRD) combustion, a rotating detonation gas turbine cycle was established using methane as fuel. The variation of pressure gain characteristic and its influence on cycle performance at different compressor pressure ratios and air distribution proportions were investigated combined with a series of two-dimensional numerical simulations. The results were demonstrated that compared with the conventional approximate iso-pressure combustion, rotating detonation combustion could significantly improve the thermodynamic performance of gas turbine in various conditions. Due to the difference of entropy generation between rotating detonation and iso-pressure combustion, the pressure gain characteristic of the CRD combustor was provided a higher cycle efficiency. The efficiency gain was higher at lower compressor pressure ratio and air proportion entering CRD combustor. In the calculated cases, the pressurization ratio of the CRD combustor was higher than 1.37, cycle efficiencies of rotating detonation gas turbine were reached 0.395, cycle efficiency increasing rates were more than 22.5%, and power generation enhancements were greater than 1500 kW.
23 September 2021 in IEEE Transactions on Circuits and Systems II: Express Briefs
In this article, the transient $H_{\infty }$ tracking performance, i.e., finite-time $H_{\infty }$ tracking control, of switched linear parameter-varying (LPV) aero-engine models over a finite-time horizon is studied utilizing dynamic event-triggered method. For this purpose, a novel dynamic event-triggered mechanism (DETM) is constructed. It is shown that under the proposed method, transmission times of sampled information of the reference are determined by the designed DETM and transmission intervals can be adjusted with the variety of the tracking performance. The sampled information of the reference is updated when the event is triggered, and thus compared with traditional tracking methods, the transmitting cost can be reduced dramatically. An application of the control of aero-engines is demonstrated to show that the presented results are valid.
To further improve the cycle performance of gas turbines, a gas turbine cycle model based on interstage bleeding rotating detonation combustion was established using methane as fuel. Combined with a series of two-dimensional numerical simulations of a rotating detonation combustor (RDC) and calculations of cycle parameters, the pressure gain characteristics and cycle performance were investigated at different compressor pressure ratios in the study. The results showed that pressure gain characteristic of interstage bleeding RDC contributed to an obvious performance improvement in the rotating detonation gas turbine cycle compared with the conventional gas turbine cycle. The decrease of compressor pressure ratio had a positive influence on the performance improvement in the rotating detonation gas turbine cycle. With the decrease of compressor pressure ratio, the pressurization ratio of the RDC increased and finally made the power generation and cycle efficiency enhancement rates display uptrends. Under the calculated conditions, the pressurization ratios of RDC were all higher than 1.77, the decreases of turbine inlet total temperature were all more than 19 K, the power generation enhancements were all beyond 400 kW and the cycle efficiency enhancement rates were all greater than 6.72%.
1 January 2017 in Mathematical Problems in Engineering
As one of the antisurge techniques, the adjusting scheme of VSV under off‐design conditions has a significant impact on the performance of gas turbines. In this paper, the one‐dimensional characteristic of the compressor calculation program is embedded into the zero‐dimensional overall gas turbine model, which replaces the original compressor characteristic module. Based on the assembling relationship of the actual components of the marine gas turbine, the architecture of the modular model library is designed, and an integrated simulation platform of marine gas turbine is developed by using MATLAB/GUI software. The influence of the first 3 rows of variable stator vanes of the 9‐stage axial compressor working alone on the performance of the compressor at different speeds and different angles was analyzed by the HARIKA compressor characteristic calculation program. Taking the economics and stability of the gas turbine as the optimization objective, the optimization of the first three‐stage stator vanes regulation schemes under different working conditions was carried out. The steady‐state performance parameters under each working condition of gas turbine of power generation with or without variable stator vane mode were calculated. The study results can provide references for the adjusting scheme of VSV under gas turbine off‐design conditions operating process.
1 January 2017 in Mathematical Problems in Engineering
The intercooled gas turbine obtained by adopting an indirect heat exchanger into an existing gas turbine is one of the candidates for developing high‐power marine power units. To simplify such a strong coupled nonlinear system reasonably, the feasibility and availability of qualifying equivalent effectiveness as the only parameter to evaluate the intercooler behavior are investigated. Regarding equivalent effectiveness as an additional degree of freedom, the steady state model of a marine intercooled gas turbine is developed and its off‐design performance is analyzed. With comprehensive considerations given to various phase missions of ships, operational flexibility, mechanical constraints, and thermal constraints, the operating curve of the intercooled gas turbine is optimized based on graphical method in three‐dimensional performance space. The resulting operating curve revealed that the control strategy at the steady state conditions for the intercooled gas turbine should be variable cycle control. The necessity of integration optimization design for gas turbine and intercooler is indicated and the modeling and analysis method developed in this paper should be beneficial to it.