To implement the various movement control of the hexapod robot, a motion controller based on the double-layered central pattern generator (CPG) is proposed in this paper. The novel CPG network is composed of a rhythm layer and a pattern layer. The CPG neurons are constructed based on Kuramoto nonlinear oscillator. The parameters including the frequency, coupling strength, and phase difference matrix of the CPG network for four typical gaits are planned. The mapping relationship between the signals of the CPG network and the joint trajectories of the hexapod robot is designed. The co-simulations and experiments have been conducted to verify the feasibility of the proposed CPG-based controller. The actual average velocities of the wave gait, the tetrapod gait, the tripod gait, and the self-turning gait are 10.8 mm/s, 25.5 mm/s, 37.8 mm/s and 26°/s, respectively. The results verify that the hexapod robot with the proposed double-layered CPG-based controller can perform stable and various movements.
The kinematics parameter error is the main error factor that affects the absolute accuracy of industrial robots. The absolute accuracy of industrial robots can be effectively improved through kinematics calibration. The error model-based method is one of the main methods for calibrating the kinematics parameter error. This paper presents a kinematics parameter calibration method for serial industrial robots based on partial pose measurement. Firstly, the kinematics and the pose error models have been established based on the modified Denavit–Hartenberg (MDH) model. By introducing the concept of error sensitivity, the average significance index is proposed to quantitatively analyze the effects of the kinematics parameter error on the pose error of a robot. The results show that there is no need to measure the full pose error of the robot. Secondly, a partial pose measurement device and method have been presented. The proposed device can measure the position error and the attitude error on the x-axis or y-axis. Finally, the full pose error model, the NP-type partial pose error model, and the OP-type partial pose error model have been applied for calibrating the kinematics parameter errors. The experimental results show that the effectiveness of the OP-type partial pose error model is consistent with the full pose error model.
Industrial robots have become more and more important in the advanced manufacturing industry. There is still a degradation problem in the accuracy performance of industrial robots after being calibrated. To maintain the accuracy performance of robots timely, a continuous kinematic calibration method is proposed. Firstly, the Modified DH (MDH) model and kinematic error model of the industrial robot have been established. Secondly, four groups of poses are measured to demonstrate the degradation of the robot’s accuracy performance. Thirdly, the continuous kinematic calibration method for accuracy maintenance based on the recursive least squares (RLS) algorithm is introduced. Finally, several experiments were conducted to verify the efficiency of the continuous calibration method based on the RLS algorithm. The RLS algorithm can achieve better efficiency and stability than the Levenberg–Marquardt (LM) algorithm. When 15 updated poses are used for parameter identification, the continuous calibration method based on the RLS algorithm can improve accuracy by 84.31%. Besides, the proposed continuous calibration method based on the RLS algorithm not only can save calculation time by 69.52% but also can reduce measurement time by 70%.
The problem of the insufficient accuracy performance of industrial robots in high-precision manufacturing is addressed in this paper. Firstly, a kinematic error model based on an M-DH model was presented. Secondly, a hybrid observability index O6 was proposed to select the optimal poses for parameter identification. O6 is the combination of O1 and O3. The optimal poses were obtained by using the IOOPS algorithm. Thirdly, the fitness function for parameter identification was established, and the Levenberg–Marquardt (LM) algorithm was applied for the accurate identification of kinematic parameter errors. Finally, several experiments were conducted to evaluate the performance of the proposed hybrid observability index O6. The average position error and average attitude error of Staubli TX60 robot were reduced by 89% and 49%. The results show that the proposed hybrid observability index O6 has great stability and effectiveness for robot calibration.