In order to investigate the internal curing effect of recycled brick aggregate (RBA) in recycled aggregate concrete (RAC) and calculate its contribution to the final compressive strength, two RAC groups with different recycled aggregates and 6 replacement ratios (r) under 4 curing ages were tested. Results show that the compressive strengths of RACI and RACII decrease steadily with the increase of r when below 40%, and that there is a significant drop once the r is higher than 60%. The internal curing effect for RAC with a low RBA ratio is mainly reflected during the curing age of 14–21 days, while for RAC with a high RBA ratio, this internal curing effect appears earlier, during 7–14 days, and becomes very obvious after 14 days. In addition, the actual tested compressive strength of RAC replaced by 100% RBA exceeds around 40% of the expected compressive strength at the age of 28 days. When the age of RAC entirely with RBA is 28 days, the compressive strength caused by the internal curing effect accounts for around 28% of the actual tested compressive strength. The most appropriate r of RBA for RAC production is between 40% to 60%. Finally, the equations for calculating the compressive strength of RAC are presented considering the curing ages, the replacement ratios and the internal curing effect of RBA. Further, a unified equation is suggested for convenience in calculation.
1 October 2020 in Journal of Materials in Civil Engineering
In order to avoid certain construction difficulties in a traditional steel reinforced concrete (SRC) structure, like the interference between reinforcing steel and rebars or poor concrete pouring quality, steel–steel fiber–reinforced concrete (SSFRC) was proposed by removing the steel rebars from SRC and incorporating steel fibers. According to a standard push-out test of 36 specimens, this paper studies the bearing and damage mechanism in the bond interface between steel and steel fiber–reinforced concrete (SFRC). The results show that splitting cracks usually elongate from the concrete surface to the interface while bonding cracks elongate from the tips of a steel flange toward the concrete surface in the 45° diagonal direction. The external loading is transferred to the bond interface through steel near the free end, forming the compression stress and bond shear stress, and then, those stresses at the interface are transferred to the bottom SFRC surface at the loading end through an inclined compression band inside the SFRC. The SFRC blocks separated by cracks achieved stress balance under the bearing stress from steel at the interface and the clamping stress from nearby SFRC blocks along the bonding cracks. The SFRC cover mainly takes the bending effect from the compression stress when the thickness of the concrete cover ranges from 19.5 to 40 mm in this paper, but it takes the shear effect when the thickness of the concrete cover is larger than 40 mm. It is worth noting that the flexural strength of the concrete with a steel fiber ratio ( ) of 3% is not significantly improved, but the ultimate bond strength is increased by 17.63% compared with that of . In addition, the calculation formulas of the ultimate bond strength, including the chemical bond stress, mechanical interlocking stress, and frictional stress, are proposed.
13 January 2018 in Arabian Journal for Science and Engineering