The development of photodetectors is crucial in fields such as optical communication, image sensing, medical devices and military equipment, where high sensitivity is paramount. We fabricated an ambipolar photodiode using monolayer triclinic ReSe2, synthesized by chemical vapor deposition on p-type Si substrate. The photodetector has a broadband response range from 405 to 1100 nm. The device exhibits high sensitivity to NIR radiation with a high Iph/Idark (ON/OFF) ratio of 5.8 × 104, responsivity (R) of 465 A/W, and specific detectivity (D) of 4.8 × 1013 Jones at open circuit voltage (Voc), indicating photovoltaic behavior. Our ReSe2/Si heterojunction photodetector also exhibits low dark current of 1.4 × 10-9 A and high external quantum efficiency (EQE) of 54368.2% for 1060 nm at -3 V, demonstrating a photoconductive gain. The maximum responsivity (R = 465 A/W) can be achieved at -3 V reverse bias under 1060 nm. The device has a high ideality factor (4.8) and power coefficient (α = 0.5), indicating the presence of interface and sub-gap states that enhance device responsivity at lower illumination intensities by re-exciting trapped carriers into the conduction band. Our results offer important insights into the underlying photo-physics of the ReSe2/Si heterojunction and propose promising avenues for developing advanced broadband photodetectors of high performance.
Recently, hydrogen (H2) energy has attracted attention among eco-friendly energy sources because H2 energy is eco-friendly, energy-efficient, and abundant in nature. However, when the concentration of H2 in the atmosphere is more than 4%, H2 has a risk of explosion. H2 is a colorless, tasteless, and odorless gas that is difficult to detect with human senses. Therefore, developing an optimized hydrogen sensor is essential. Palladium (Pd) has good reactivity to hydrogen. Molybdenum disulfide (MoS2) has high carrier mobility, sensitive reactivity to toxic gases, and high surface-area-to-volume ratio. Therefore, we proposed hydrogen sensors that use Pd and MoS2. The main fabrication processes include MoS2 deposition through CVD and Pd deposition through DC sputtering. In this study, we utilized Pd and MoS2 to enable sensing at room temperature. By optimizing the Pd to a nanoparticle structure with an expansive surface area of 4 nm, we achieved a fast response time of 4–5 s and an enhanced yield through a simplified structure. Hydrogen sensors inherently exhibit sensitivity to various environmental factors. To address these challenges, technologies such as machine learning can be incorporated. Emphasizing low-power consumption and various application compatibilities becomes pivotal to promoting commercialization across diverse industries.
20 March 2023 in Korean Journal of Chemical Engineering