In this paper, a step-up seven-level inverter supplied by a single DC source suitable for renewable energy application is presented. Forming the desired output is realized by charging capacitors and synthesizing them based on switched-capacitor concept. This structure is praised for the ability of sensor-less voltage balancing of the capacitors, reducing control complexity to produce a bipolar staircase waveform. It also benefits from regenerative performance, avoiding unwanted capacitors overvoltage. Phase Disposition Pulse Width Modulation technique is utilized to control the circuit operation. Furthermore, a comparison with other recent topologies reveals that losses, number of semiconductor devices, and gate driver circuits are reduced. Theoretical analysis is verified through a laboratory prototype implementation. Experimental results under various types of loads approve the performance of the proposed inverter and validity of the design. Finally, maximum experimental efficiency of 94.3% (115 V, 250 W load) was reached.
21 December 2021 in IEEE Transactions on Industrial Electronics
The necessity of using several components in multilevel inverters jeopardizes the reliability of their operation. Hence, the aim of this article is to propose a novel single-phase fault-tolerant topology based on a switched-capacitor concept to ensure the robustness of the converter in the occurrence of a fault. The proposed single-source converter steps up the input voltage seven times with a simple control strategy. Fault tolerance of the converter is achieved by considering multiple fault cases and providing several redundant switching schemes concerning the type and location of failure. Each switching scheme is designed in a way to ensure the tolerability to both single and multiple open-/short-circuit failures. Also, self-voltage balancing of the capacitors, as well as the same amount of voltage levels and amplitude in the output, is guaranteed. Experimental analysis is carried out, and the results confirm the viability of the proposed inverter under normal and postfault operating modes.
A new structure of switched capacitor multilevel inverter (SCMLI) capable of voltage boosting and with self-balancing ability is introduced in this article. This advantage is the result of a step by step rise of capacitor voltages in each module, supplied by just one DC voltage source. The proposed topology generates a sinusoidal output waveform with a magnitude several times greater than the input one. Higher output staircase AC voltage is obtained by applying a nearest level control (NLC) modulation technique. The most significant features of this configuration can be mentioned as: fewer semiconductor devices, remarkably low total harmonic distortion (THD), desirable operating under high/low frequency, high efficiency, inherent bipolar voltage production, easy circuit expansion, ease of control and size reduction of the circuit thanks to utilizing neither bulky transformer nor inductor. Moreover, the proposed SCMLI is comprehensively surveyed through theoretical investigation and a comparison of its effectiveness to recent topologies. Eventually, the operating principle of a 25-level prototype of the suggested SCMLI is validated by simulation in the MATLAB SIMULINK environment and experimental results.
This paper aims to present a novel switched-capacitor multi-level inverter. The presented structure generates a staircase near sinusoidal AC voltage by using a single DC source and a few capacitors to step-up the input voltage. The nearest level control (NLC) strategy is used to control the operation of the converter. These switching states are designed in a way that they always ensure the self-voltage balancing of the capacitors. Low switching frequency, simple control, and inherent bipolar output are some of the advantages of the presented inverter. Compared to other existing topologies, the structure requires fewer circuit elements. Bi-directional power flow ability of the proposed topology, facilitates the operation of the circuit under wide range of load behaviors which makes it applicable in most industries. Besides, a 13-level laboratory prototype is implemented to realize and affirm the efficacy of the MATLAB Simulink model under different load conditions. The simulation and experimental results accredit the appropriate performance of the converter. Finally, a theoretical efficiency of 92.73% is reached.
An AC-AC direct single-phase converter based on an impedance network is presented in this manuscript. It possesses all privileges of similar impedance source AC-AC converters such as buck-boost ability, maintaining or reversing the phase angle and sharing the same ground between input and output voltage. Furthermore, a magnetic coupling is exploited to provide high voltage gain by adjusting its turns ratio along with the duty cycle. A safe commutation strategy is implemented to avoid current and voltage spikes across switches needless to utilize snubber circuits. The presented converter offers continuous input current, and ac to ac conversion is done directly without using dc storage, making it appropriate for dynamic voltage restorer to compensate voltage sags and voltage swells. In addition, LC input and output filters are eliminated thanks to impedance network structure. In this regard, the presented topology offers good features in size and cost by reducing passive components compared to similar structures. Also, the comparative investigation shows that the proposed converter benefits from superior operational ranges among similar well-known topologies for the same conditions. Finally, theoretical analyses and operation modes of the proposed converter are discussed and testified by both simulation and experimental results.
11 April 2021 in International Journal of Electronics
In this paper, a new single-phase seven level inverter with reduced device count is introduced. The structure can boost the input voltage by synthesizing the capacitors’ voltages in predetermined current paths. A single DC voltage source is utilized to generate the output AC staircase waveform, which is facilitated via Nearest Level Control. Self-voltage balancing ability, less number of semiconductor devices, high efficiency and control simplicity are the most significant inherent attributes of the proposed circuit. It is also noticeable that in this configuration neither bulky transformer/inductor nor filters are applied. Power loss calculation and required capacitance of the proposed inverter are investigated and theoretical efficiency of 93.31% was reached. Moreover, the proposed converter operates under various load conditions with lower Total Harmonic Distortion compared to recent topologies. Ultimately, operating principles of the proposed D-Type seven-level Inverter and simulation results in MATLAB SIMULINK environment are validated by experimental ones obtained from the laboratory prototype.