Chemiresistors (conductometric sensor) were fabricated on the basis of novel nanomaterials—silica nanosprings ALD coated with ZnO. The effects of high temperature and UV illumination on the electronic and gas sensing properties of chemiresistors are reported. For the thermally activated chemiresistors, a discrimination mechanism was developed and an integrated sensor-array for simultaneous real-time resistance scans was built. The integrated sensor response was tested using linear discriminant analysis (LDA). The distinguished electronic signatures of various chemical vapors were obtained at ppm level. It was found that the recovery rate at high temperature drastically increases upon UV illumination. The feasibility study of the activation method by UV illumination at room temperature was conducted.
A chemical sensor (chemiresistor) was constructed from a xenon light bulb by coating it with a 3-D zinc oxide coated silica nanospring mat, where the xenon light bulb serves as the sensor heater. The sensor response to toluene as a function of xenon light bulb sensor temperature (TLB) and vapor temperature (TV) was observed and analyzed. The optimum operational parameters in terms of TLB and TV were determined to be 435 °C and 250 °C, respectively. The activation energy of toluene oxidation (Ed) on the ZnO surface was determined to be 87 kJ·mol−1, while the activation energy of oxidation (Ea) of the depleted ZnO surface was determined to be 83 kJ·mol−1. This study serves as proof of principle for integrating nanomaterials into an inexpensive sensor platform, which can also be used to characterize gas-solid, or vapor-solid, redox processes.
A redox chemical sensor (chemiresistor) was constructed with a single ZnO coated silica nanospring. The chemiresistor response to toluene vapor as a function of the sensor temperature (TNS) and vapor temperature (TV) was measured and analyzed. The maximum sensitivity of the single ZnO coated nanospring device occurred at the sensor temperature (TNS) of 310 °C and at the vapor temperature (TV) of 250 °C. The characteristics of the electrical response of a single ZnO coated nanospring device were compared to those of a ZnO thin film. The single ZnO nanospring sensor was less responsive to small changes in toluene concentration relative to the ZnO thin film, but has a lower ultimate detection level. A computational model to simulate an electrical response of the single nanospring sensor and the thin film indicated that the differences between their response characteristics is due to the geometry of the nanospring and corresponding periodic boundary conditions imposed by the nanospring geometry, which is absent in a thin film.