Production of fly ash zeolites may be an attractive method for the utilization of solid wastes from the energy sector. Different methods of synthesis often yield a variety of zeolite types, thereby affecting the properties of the resulting materials. The attention paid to carbon dioxide emission reduction technologies fully justifies the study of the sorption behaviours of fly ash zeolites synthesized by different methods. This work investigates the sorption properties of fly ash zeolites synthesized with different methods using CO2. Sorption capacity and adsorption isotherms were determined following the volumetric method and textural parameters were resolved according to the Dubinin-Astakhov (DA) method. The CO2 sorption capacity was in the range 0.24–4.16 mmol/g. The relationships between structure and sorption behaviour were studied for each synthesis method. Some strong similarities between commercial zeolites and fly ash zeolites were found. The mechanism for sorption was proved to be physisorption which is fully reversible under selected conditions. The observed trends were used to identify the best sorbent.
13 November 2018 in Adsorption Science & Technology
Synthesis of zeolites from fly ash is an ecologically justified process aimed at the transformation of energy sector waste – fly ash into microcrystalline zeolites of broad possible application field. In this study, the synthesis of zeolites from fly ash by using a modified two-step synthesis was presented. The aim of such a planned experiment was to use the waste solutions from previous synthesis, in such a way that minimalization of negative influence of post-synthesis wastes on environment was possible. Received materials were tested for its sulfur dioxide sorption capacity, indicating its future possible application to capture SO2 from exhaust gases.
Expansion/contraction of coal, induced by the sorption of carbon dioxide and methane in isothermal and non-isothermal conditions, was measured. The investigation is of great importance in the context of validating the potential CO2 sequestration in unmined coal seams. Changes in temperature in underground coal beds can influence the sorption balance, resulting in strains in coal strata, which could lead to the desorption of gas and leaks to the ground surface. The research shows that the strains induced by CO2 sorption are about twice the size of those resulting from the sorption of CH4. The linear strains are anisotropic and greater in the direction perpendicular to the bedding plane. The results of the non-isothermal experiments show that a temperature increase gives rise to the sample swelling in the presence of methane, but a different pattern is observed for coal–CO2 systems, where sample contraction occurs. This behaviour is explained by the different mechanism of CH4 and CO2 deposition and by the diversity in the maceral composition of the samples.
This paper presents experimental results of the sorption-dilatometric kinetics of methane and carbon dioxide on a sample of hard coal from one of the coal mines in the Upper Silesian Coal Basin. The experiment included isothermal and non-isothermal-isobaric stages. For the isothermal stage, it was found that, up to a certain point (about 8 dm3/kg), the sample’s expansion was linearly related to the amount of gas absorbed. Studies on dilatometric kinetics under constant pressure, with a reduction in temperature, indicate that a dominant share of the heat-expanding properties of carbonaceous material influences changes in the size of the sample in the coal-gas system. It was also found that the sample expansion, due to temperature change, was 2.25‰, for the sample in both the vacuum and the non-adsorbing gas atmosphere.