This review article, dedicated to the bicentenary celebration of Sir George Gabriel Stokes' birthday, presents the state-of-the-science of terminal fall velocity, highlighting his rich legacy from the perspective of fluvial hydraulics. It summarizes the fluid drag on a particle and the current status of the drag coefficient from both the theoretical and empirical formulations, highlighting the three major realms—Stokesian, transitional and Newtonian realms. The force system that drives the particle motion falling through a fluid is described. The response of terminal fall velocity to key factors, which include particle shape, hindered settling and turbulence (nonlinear drag, vortex trapping, fast tracking and effects of loitering), is delineated. The article puts into focus the impact of terminal fall velocity on fluvial hydraulics, discussing the salient role that the terminal fall velocity plays in governing the hydrodynamics of the sediment threshold, bedload transport and suspended load transport. Finally, an innovative perspective is presented on the subject's future research track, emphasizing open questions.
The turbulence characteristics in flow over and within the interface of two-dimensional dunes are investigated experimentally. Besides the spatial flow and turbulence quantities, their double-averaged profiles are also analyzed. The flow over dunes is recognized to be a wake-interference flow, where the decelerated flow at the immediate downstream of the crest causes the kolk-boil effect. The flow reattachment can be explained from the perspective of the Coandă effect. The inner boundary layer edge follows the locus of the inflection points of velocity profiles having a velocity defect. The Reynolds shear stress profiles attain their respective peaks along this locus. In addition, the dispersive shear stress initiates from the edge of the form-induced sublayer being negative, indicating a spatially decelerated flow. The third-order correlations reveal that an inrush of rapidly moving fluid streaks coupled with a downward-downstream Reynolds stress diffusion prevails within the interfacial sublayer, while an arrival of slowly moving fluid streaks coupled with an upward-upstream stress diffusion governs the flow zone above the crest. The turbulent kinetic energy (TKE) flux results corroborate the similar findings. Concerning the TKE budget, the dispersive kinetic energy diffusion is found to be substantial within the roughness sublayer. The budget terms exhibit their respective peaks near the crest. The production rate is greater than the dissipation rate. However, the TKE diffusion and pressure energy diffusion rates are negative in the interfacial sublayer. The bursting analysis endorses that the sweeps and ejections govern within the interfacial sublayer and the flow zone above the crest, respectively.
The turbulence characteristics within flows over water-worked gravel beds (WGBs) and screeded gravel beds (SGBs) were examined by measuring the instantaneous flow velocity field using a two-dimensional particle image velocimetry system. To compare the responses of a WGB and an SGB to velocity and various turbulence characteristics, the flow Froude number was kept identical for both the beds that remained immobile. The roughness structures of both the beds were measured using a laser scanner. The results showed that the bed surface roughness was higher in the WGB than in the SGB. However, the longest axis of the gravels of WGBs was oriented streamwise owing to the action of water work, but the gravels of SGBs were randomly poised. The distribution of bed roughness fluctuations was negatively skewed in the WGB and positively skewed in the SGB. Double averaging methodology was applied to analyze the flow parameters. In this paper, the vertical profiles of the double-averaged streamwise velocity and the turbulence parameters, specifically the spatially averaged (SA) Reynolds shear and normal stresses, form-induced shear and normal stresses, turbulent kinetic energy (TKE) and form-induced TKE fluxes, quadrant analysis of SA Reynolds shear stress, etc., are presented and analyzed critically by focusing on comparisons between a WGB and an SGB. A comparative study reveals that in the near-bed flow zone, the SGB underestimates the turbulence parameters compared to the WGB. Therefore, in order to represent the prototypical flow in laboratory, the experiments should be performed in a WGB.
Coherent structures and their impact on the near-bed time-averaged flow structure in a water-worked gravel-bed (WGB) and a screeded gravel-bed (SGB) are analyzed. Instantaneous velocities were measured using a particle image velocimetry system in the WGB and SGB flows in a flume with rectangular cross section. To ascertain the response of the WGB with respect to the SGB to the coherent structures, the time- and double-averaged flow, and the spatially averaged (SA) turbulence parameters, the experimental flow conditions for both the beds were kept identical. The surface gravels in the WGB were spatially organized owing to the water action. By contrast, the surface gravels in the SGB were randomly poised. These result in a higher roughness height in the WGB than in the SGB. Time series analysis for the instantaneous velocity and vorticity on a central vertical plane along the streamwise direction proves that the coherent structures in the near-bed flow zone are constituted by rapidly and slowly moving fluid streaks. Besides, the time-averaged streamwise velocity, vorticity, turbulence level, third-order correlations, and turbulent kinetic energy (TKE) budget are analyzed in the WGB and SGB. Their contours are plotted on the central vertical plane to study their spatial distributions. In addition, the SA higher-order correlations and TKE budget in the WGB and SGB are examined. A comparative study infers that the higher roughness in the WGB than in the SGB causes both the time-averaged and SA turbulence parameters in the former to be greater than those in the latter.
The characteristics of the spatially averaged (SA) turbulent kinetic energy (TKE) dissipation rate are studied experimentally in flows over water-worked gravel beds (WGBs) and a screeded gravel bed (SGB) measuring the instantaneous velocity field by the Particle Image Velocimetry system. To study the response of water work roughness to the TKE related parameters, the flow Froude numbers in both the WGB and SGB were maintained identical in the experiments. Owing to the action of water work, the surface gravels in the WGB are more spatially organized than those of the SGB, where they are randomly oriented, resulting in a higher roughness in the WGB than in the SGB. Examination of the second- and the third-order velocity structure functions reveals the evidence of an inertial subrange in both the WGB and SGB. Kolmogorov’s two-thirds and four-fifths laws are preserved within the inertial subrange, providing an accurate estimation of the TKE dissipation rate in both the beds. However, owing to the higher roughness in the WGB than in the SGB, the TKE and the scaling law parameters are greater in the former than in the latter case. Furthermore, to examine the effects of the shear Reynolds number on the TKE dissipation rate and the scaling law parameters, two additional experiments with different shear Reynolds numbers were conducted with the WGBs. The comparative results suggest that the SA TKE dissipation rates estimated from Kolmogorov’s two-thirds and four-fifths laws increase with an increase in the shear Reynolds number in the WGBs.
28 October 2020 in Proceedings of the Royal Society A: Mathematical, Physical and Engineering Sciences
Characteristics of turbulence anisotropy in flow over two-dimensional rigid dunes are analysed. The Reynolds stress anisotropy is envisaged from the perspective of the stress ellipsoid shape. The spatial evolutions of the anisotropic invariant map (AIM), anisotropic invariant function, eigenvalues of the scaled Reynolds stress tensor and eccentricities of the stress ellipsoid are investigated at various streamwise distances along the vertical. The data plots reveal that the oblate spheroid axisymmetric turbulence appears near the top of the crest, whereas the prolate spheroid axisymmetric turbulence dominates near the free surface. At the dune trough, the axisymmetric contraction to the oblate spheroid diminishes, as the vertical distance below the crest increases. At the reattachment point and one-third of the stoss-side, the oblate spheroid axisymmetric turbulence formed below the crest appears to be more contracted, as the vertical distance increases. The AIMs suggest that the turbulence anisotropy up to edge of the boundary layer follows a looping pattern. As the streamwise distance increases, the turbulence anisotropy at the edge of the boundary layer approaches the plane-strain limit up to two-thirds of the stoss-side, intersecting the plane-strain limit at the top of the crest and thereafter moving towards the oblate spheroid axisymmetric turbulence.