Extreme temperature and pressure conditions on the surface of Venus present formidable technological challenges against performing ground‐based seismology. Efficient coupling between the Venusian atmosphere and the solid planet theoretically allows the study of seismically generated acoustic waves using balloons in the upper atmosphere, where conditions are far more clement. However, earthquake detection from a balloon has never been demonstrated. We present the first detection of an earthquake from a balloon‐borne microbarometer near Ridgecrest, CA in July 2019 and include a detailed analysis of the dependence of seismic infrasound, as measured from a balloon on earthquake source parameters, topography, and crustal and atmospheric structure. Our comprehensive analysis of seismo‐acoustic phenomenology demonstrates that seismic activity is detectable from a high‐altitude platform on Earth, and that Rayleigh wave‐induced infrasound can be used to constrain subsurface velocities, paving the way for the detection and characterization of such signals on Venus.

Seismology on Venus has long eluded planetary scientists due to extreme temperature and pressure conditions on its surface, which most electronics cannot withstand for mission durations required for ground-based seismic studies. We show that infrasonic (low-frequency) pressure fluctuations, generated as a result of ground motion, produced by an artificial seismic source known as a seismic hammer, and recorded using sensitive microbarometers deployed on a tethered balloon, are able to replicate the frequency content of ground motion. We also show that weak, artificial seismic activity thus produced may be geolocated by using multiple airborne barometers. The success of this technique paves the way for balloon-based aero-seismology, leading to a potentially revolutionary method to perform seismic studies from a remote airborne station on the earth and solar system objects with substantial atmospheres such as Venus and Titan.

We conducted an experiment in Pahrump, Nevada, in June 2017, where artificial seismic signals were created using a seismic hammer, and the possibility of detecting them from their acoustic signature was examined. In this work, we analyze the pressure signals recorded by highly sensitive barometers deployed on the ground and on tethers suspended from balloons. Our signal processing results show that wind noise experienced by a barometer on a free‐flying balloon is lower compared to one on a moored balloon. This has never been experimentally demonstrated in the lower troposphere. While seismoacoustic signals were not recorded on the hot air balloon platform owing to operational challenges, we demonstrate the detection of seismoacoustic signals on our moored balloon platform. Our results have important implications for performing seismology in harsh surface environments such as Venus through atmospheric remote sensing.

Infrasound recorded in the middle stratosphere suggests that the acoustic wavefield above the Earth's surface differs dramatically from the wavefield near the ground. In contrast to nearby surface stations, the balloon‐borne infrasound array detected signals from turbulence, nonlinear ocean wave interactions, building ventilation systems, and other sources that have not been identified yet. Infrasound power spectra also bore little resemblance to spectra recorded on the ground at the same time. Thus, sensors on the Earth's surface likely capture a fraction of the true diversity of acoustic waves in the atmosphere. Future studies building upon this experiment may quantify the acoustic energy flux from the surface to the upper atmosphere, extend the capability of the International Monitoring System to detect nuclear explosions, and lay the observational groundwork for a recently proposed mission to detect earthquakes on Venus using free‐flying microphones.

Infrasound waveforms generated by natural and anthropogenic phenomena contain important clues about the size and nature of the event. We show that sensors on balloons in the lower stratosphere can record faithful representations of the near‐source acoustic wave field at unprecedented range. The acoustic signature of a buried chemical explosion recorded at a range of 56 km and an altitude of 21.8 km was nearly identical to that recorded on the ground 0.5 km from the epicenter, but absent on a ground sensor located 46 km away. Our results demonstrate that balloon‐borne infrasound techniques greatly increase the range at which well‐preserved acoustic representations of near‐source physics can be acquired, and that their propagation is simple to model. Our work has implications for monitoring remote regions of the earth for explosions, volcanic eruptions, and other phenomena. It also supports the prospect of balloon‐based infrasound seismology on Venus.