The adsorption processes of methylene blue from aqueous solution on Fe3O4/HKUST-1 and Fe3O4/HKUST-1/GO composites were compared. The addition of GO has greatly decreased the surface area and pore volume, led to smaller pore size, and enhanced the adsorption capacity of Fe3O4/HKUST-1/GO. The different interesting phenomena and the effect of GO were analyzed. The high adsorption capacity, excellent reusability and stability make Fe3O4/HKUST-1/GO attractive for the removal of MB from aqueous solution.
1 May 2021 in Journal of Colloid and Interface Science
A renewable metal–organic-frameworks (MOFs)-polylactic acid (PLA) film was designed and prepared in order to remove malachite green (MG) in waste water. The PLA frame was prepared by three-dimensional (3D) printing technology, followed by in situ step-by-step growth of Cu-MOFs on its surface. The printed PLA skeleton and the prepared Cu-MOFs/PLA films were characterized by scanning electron microscopy and X-ray powder diffraction. The adsorption capacity of Cu-MOFs/PLA films towards MG was then investigated. Results showed that more than 90% removal efficiency was observed in adsorbing MG of different concentrations for 10 min. Practical applications of Cu-MOFs/PLA films for removal of MG in waste-water samples were then demonstrated. The used Cu-MOFs/PLA films were found to be recyclable over more than five times after simple washing with acetone. In addition, it was noted that the PLA skeleton could be recovered for the further growth of Cu-MOFs on its surface. The successful development of this technique provides a new strategy for the design of renewable materials for the adsorption of organic dyes in waste water, which holds enormous potential for broad applications in waste-water treatment.