Computational and theoretical studies of a Mach 5 flow over a hemisphere were carried out to validate a new computer code for magnetogasdynamic simulation, and to examine the possibility of heat transfer mitigation through magnetic control. Sample calculations were made using a local solution developed by W. B. Bush [J. Aerosp. Sci. 25, 685 (1958); 28, 610 (1961)] for the stagnation point flow over an axisymmetric blunt body with an imposed dipole magnetic field. Numerical computations, which obviated many of the simplifications inherent in the Bush theory, were carried out employing the low magnetic Reynolds number approximation. Both models indicate that an imposed dipole field can slow the flow in the conductive shock layer and consequently reduce the wall heat flux in the vicinity of the stagnation point. The theoretical model predicts a slightly higher level of heat transfer than that obtained computationally, but there is good agreement between the two models in the fractional change in heat transfer with increasing strength of the applied magnetic field. For both models, nonuniform electrical conductivity was found to reduce the effectiveness of a given applied field. Magnetic flow control is seen to have a sound physical basis, and may prove to be a useful technology for heat transfer mitigation.
A study of the shock-wave/boundary-layer interaction induced by a compression ramp was carried out using high-fidelity simulations. The objective was to investigate the influence of upstream disturbances on low-frequency separation unsteadiness. Two computations were performed for a 24° compression ramp at Mach 2.25, one highly resolved case and one reduced-resolution case. The reduced-resolution case was run for an extended duration to capture many cycles of low-frequency unsteadiness. Basic flow characteristics, including statistics on the boundary layer, wall pressure, and skin friction, were computed. Frequency spectra were calculated to confirm the presence of low-frequency unsteadiness. The influence of upstream disturbances on large-scale separation unsteadiness was investigated using correlations, filtering, and conditional averaging based on the position of the primary separation shock. Low-frequency unsteadiness was found to be related to structures near the wall (y/δ < 0.5) with a time scale greater than 20δ/U∞, whereas higher frequency separation motion could be attributed to turbulent boundary layer structures with a time scale on the order of δ/U∞. The finding that the separation region responds selectively to certain large-scale, near-wall perturbations in the incoming flow supports a model of separation unsteadiness in which external forcing by certain components of boundary layer turbulence drives a weakly damped global mode of the separation bubble. This contrasts with suggestions that have been made in the literature that the separation region oscillates on its own, as in an amplified global mode.