VO2 (M) thin films with good optical switching properties have been grown by reactive sputtering method. The influence of sputtering parameters on the structural and optical properties of the as-grown VO2 thin films was investigated, and the correlation between the microstructure and optical switching properties were studied. It was found that the phase transition temperature, hysteresis width, and the amplitude of the transition depend on the sputtering gas pressure, and the amplitude of the transition can reach as high as 70% with an approximately zero infrared transmission in metal state at a wavelength of 2.5 μm. The anomalous optical properties of the VO2 thin films were analyzed and discussed together with the studies of the refractive index and optical band gap.
The composites of polyaniline and TiO2 nanoparticles with different contents were prepared in the aqueous solution of phosphoric acid, in which the phosphoric acid was selected as the protonic acid to improve the conductivity of polyaniline. In the composites, the TiO2 nanoparticles with the size of about 20 nm were coated by a layer of polyaniline film with a thickness of about 5 nm. Then, the gas sensors were constructed by a liquid–gas interfacial self-assembly method. The gas-sensing properties of the composites-based gas sensors obviously improved after doping with TiO2 nanoparticles, and the sensor response of the composites increased several times to NH3 from 10 ppm to 50 ppm than that of pure polyaniline. Especially when the mass ratio of TiO2 to aniline monomer was 2, it exhibited the best gas response (about 11.2–50 ppm NH3), repeatability and good selectivity to NH3 at room temperature. The p–n junction structure consisting of the polyaniline and TiO2 nanoparticles played an important role in improving gas-sensing properties. This paper will provide a method to improve the gas-sensing properties of polyaniline and optimum doping proportion of TiO2 nanoparticles.
17 September 2020 in Journal of Materials Chemistry C
The low enhancement factor of semiconductor SERS substrates is a major obstacle for their practical application. Therefore, there is a need to explore the facile synthesis of new SERS substrates and reveal the SERS enhancement mechanism. Here, we develop a simple, facile and low-cost two-step method to synthesize copper sulfide based nanostructures with different Cu7.2S4 contents. The as-synthesized sample is composed of nanosheets with the CuS phase structure. With the increase of the annealing temperature to 300 °C, the CuS content gradually decreases and disappears, and the content of Cu7.2S4 and CuSO4 appears and gradually increases. At the annealing temperature of 350 °C, only CuSO4 exists. Compared with pure CuS or pure CuSO4, the detection limit of R6G molecules is the lowest for the composite sample with a higher content of Cu7.2S4, indicating that the introduction of non-stoichiometric Cu7.2S4 can improve the SERS performance and the higher content of Cu7.2S4 leads to a higher SERS activity. Furthermore, to investigate the SERS mechanism, the energy band structures and energy-level diagrams of different probe molecules over CuS, Cu7.2S4 and CuxS are studied by DFT calculations. Theoretical calculations indicate that the excellent SERS behavior depends on charge transfer resonance. Our work provides a general approach for the construction of excellent metal compound semiconductor SERS active substrates.
9 January 2023 in Journal of Physics D: Applied Physics
Surface-enhanced Raman scattering technique has become a powerful tool for detecting trace targets in the field of food-safety. However, it is a challenge to regulate the hot spots of the detection substrate and its interaction with target molecules for the enhancement of SERS activity. Herein, we reported the high performance SERS substrate based on Ag@ZIF-67 nanocomposite with sugar-coated haws like structure. It was found that the coverage of ZIF-67 particles on the surface of Ag nanowires can adjust the SERS ability of detection substrate. Compared with pure Ag nanowires, functionalized Ag nanowires exhibit outstanding SERS activity with good stability and uniformity. The detection limit of crystal violet and thiram can be as low as 10−10 M and 10−8 M, respectively. After 35 d, the SERS activity remains basically unchanged. Furthermore, it also has excellent SERS response to 5 10−5 M thiram residues on the surface of vegetables. Such high SERS activity can be attributed to the enrichment and screening molecular effect of porous ZIF-67 nanoparticles, and the surface plasmon resonance effect of Ag nanowires. This work provides a simple strategy for the on-site detection of pesticide residues in the actual applications.