Gaseous emissions from vehicles contribute substantially to air pollution and climate change. Vehicular emissions also contain secondary pollutants produced via chemical reactions that occur between the emitted gases and atmospheric air. This study aims at understanding patterns concerning emission of regulated, greenhouse, and precursor gases, which demonstrate potential for secondary aerosol (SA) formation, from vehicles incorporating different engine technologies—multi-point injection (MPI) and gasoline direct injection (GDI)—and using different fuels—gasoline, liquefied petroleum gas (LPG), and diesel. Drive cycles from the National Institute of Environmental Research (NIER) were used in this study. Results obtained from drive cycle tests demonstrate a decline in aggregate gas emissions corresponding to an increase in average vehicle speed. CO2 accounts for more than 99% of aggregate gaseous emissions. In terms of concentration, CO and NH3 form predominantly non-CO2 emissions from gasoline and LPG vehicles, whereas nitrogen oxides (NOx) and non-methane hydrocarbons (NMHC) dominate diesel-vehicle emissions. A higher percentage of SO2 is emitted from diesel vehicles compared to their gasoline- and LPG-powered counterparts. EURO-5- and EURO-6-compliant vehicles equipped with diesel particulate filters (DPFs) tend to emit higher amounts of NO2 compared to EURO-3-compliant vehicles, which are not equipped with DPFs. Vehicles incorporating GDI tend to emit less CO2 compared to those incorporating MPI, albeit at the expense of increased CO emissions. The authors believe that results reported in this paper concerning regulated and unregulated pollutant-emission monitoring can contribute towards an accurate evaluation of both primary and secondary air-pollution scenarios in Korea.
With global anthropogenic black carbon (BC) emissions increasing, automobiles are significantly contributing as the major source of emissions. However, the appropriate regulations of BC emissions from vehicles are not in place. This study examined BC emissions following fuel types (gasoline, liquefied petroleum gas (LPG), and diesel) and engine combustion (gasoline direct injection (GDI) and multi-port injection (MPI) for gasoline vehicles) with emission regulations. To this end, chassis dynamometer and aethalometer (AE33) were used. Driving modes created by the National Institute of Environmental Research (NIER) and emission certification modes (CVS-75 and NEDC) for vehicles in Korea were used to determine BC emissions for various vehicle speeds. In addition, the contributions of biomass and coal combustion to the data of AE33 were analyzed to determine the possibility of tracking the BC sources. MPI, LPG, and EURO 6 with diesel particulate filter (DPF) vehicles emitted the lowest BC emissions in NIER modes. Among gasoline vehicles, MPI vehicles showed the lower BC content in PM emissions. Also, older vehicles in MPI vehicles emitted the high PM and BC emissions. The BC emissions of EURO 3 vehicles without DPF were the highest as the results of previous studies, and it was found that as emissions regulations were tightened, the level of BC results of diesel vehicles became similar with MPI vehicles. The average absorption Ångström exponent (AAE) from difference emissions sources were biomass combustion (oak wood) > coal combustion (the power plant stack) > automobile emissions (gasoline, LPG, diesel).
This study aims to analyze the seasonal number concentrations corresponding to each particle size derived from the measurements of exhausts from approximately seven million vehicles on real-world using a pair of the scanning mobility particle sizer to determine the vehicle emission rate. The actual tunnel flow coefficient was investigated for car emission rate based on the measurements of individual physical parameters (i.e., cross section area and length of the tunnel, tunnel wind speed and traffic volume). The mode of particle diameter according to temperatures in respective seasons exhibited a high correlation together with rapid changes at temperature above the breakthrough point. The temperature acted as major cause of determination of final condensation diameter, which is also dependent on diverse environmental effects comprising particle number concentration. The traffic volume of ordinary cars increased by more than twice as much in the period of Asian New Year, the traffic volume of buses/RVs/trucks decreased by more than 25% during weekdays. As a result, the particle number concentration discharged from a unit vehicle was 6.96 × 1012 N/veh·km during weekdays, and the values of weekends appeared as 6.08 × 1012 N/veh·km. The overall averaged particle number concentration based on the actual seasonal road measurements shows 5.82 × 1012 N/veh·km.