This paper considers a hydrostatic–seasonal–time (HST) statistical model for predicting the settlement behavior of a concrete-faced rockfill dam (CFRD) during operation. The constituents of the model are innovatively related to viscoelastic–plastic material model components, with the novel addition of considering unloading–reloading behavior when determining the model parameters. The statistical model developed considers both load-related and time-related deformation behavior of rockfill and CFRDs. The discussion compares different functions from the literature describing time-dependent deformation of rockfill dams and CFRDs and emphasizes cautious selection of predictors to enhance any statistical model’s credibility. The model is applied to the case of the 200-m-high Kárahnjúkar CFRD. The aim of the statistical analysis is first to create a prediction model for short- and long-term settlements of the dam, and second to extract behavioral patterns for structural-health monitoring applications. This is important for the operational safety of large dams, and thus the resilience and sustainability of related civil infrastructure systems.

Landslide-generated impulse waves in dammed reservoirs run up the reservoir banks as well as the upstream dam slope. If large enough, the waves may overtop and even breach the dam and cause flooding of the downstream area with hazardous consequences. Hence, for reservoirs in landslide-prone areas, it is important to provide a means to estimate the potential size of an event triggered by landslides along the reservoir banks. This research deals with landslide-generated waves and the overtopping process over the dam crest in a three-dimensional (3D) physical model test, presenting a case study. The model set-up describes the landslide impacting the reservoir in a perpendicular manner, which is often the case in natural settings. Based on the experimental results, dimensionless empirical relations are derived between the overtopping volume and the governing parameters, namely the slide volume, slide release height, slide impact velocity, still-water depth, and upstream dam face slope. Predictive relations for the overtopping volume are presented as applicable for cases relating to the specific model set-up. Measured overtopping volumes are further compared to a two-dimensional (2D) case reported in the literature. An important feature regarding the overtopping process for the 3D case is the variation in time and space, resulting in an uneven distribution of the volume of water overtopping the dam crest. This observation is made possible by the 3D model set-up, and is of value for dam safety considerations as well as for foundation-related issues, including erosion and scouring.

There are increasing demands from dam safety regulations and guidelines to upgrade the rockfill dams, especially in Norway where over 180 large rockfill dams are present. To protect the hydraulic structure against overtopping events or leakages, it is important to use defence mechanisms such as a protective layer of riprap on the downstream slope. In this article, we display 9 experimental setups of riprap, conducted at the hydraulic laboratory of NTNU (Trondheim) and subjected to overtopping phenomena with increasing water discharge, until the complete failure of the model. These tests were performed on models with dumped and placed riprap, with or without toe support, with or without the downstream rockfill shoulder, and finally on models with a full dam profile. The models with downstream rockfill shoulder as well as with full dam profiles allowed for throughflow. The model behaviour during these experimental tests is described and discussed, according to their respective critical discharge values and associated failure mechanisms. Limitations are also discussed. The results bring to light the benefit of placed riprap compared to dumped riprap structures. As the results show a placed riprap can withstand a significantly higher overtopping discharge than a dumped riprap. Also, the use of toe support enables a significant increase of resistance against overtopping of placed riprap structures. However, toe supports have not proven any significant improvement in stability for dumped riprap structures. This research also puts forward that dumped riprap undergoes a surface erosion process with smaller slides. Placed riprap undergoes a sliding failure mechanism when unsupported at the toe, and a buckling deformation when supported.

Rockfill dams must be equipped with defence mechanisms to counteract the destabilizing effects of throughflow forces under accidental leakage scenarios. A key component of the rockfill dam overtopping system is the rockfill dam toe, constructed in tandem with the downstream rockfill shoulder. Quantitative descriptions of effects of different toe configurations on throughflow hydraulic properties of rockfill dams are currently unavailable in international literature. To address this, experimental investigations were conducted on 1 m high model rockfill dams with disparate toe configurations. Investigation outcomes describe the effects of internal, external and combined toe configurations on pore-pressure distributions within rockfill dam models subjected to throughflow conditions. Research outcomes provide vital information which can facilitate effective decision-making with regards to rockfill dam design. The accumulated data sets could also enable development, calibration and validation of numerical design tools and dam breach models.