David López

David López


Research Focus & Metrics

Academic Career Length

17Years (2010-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
1 January 2010 in Journal of Hydraulic Research
Verified
Journal Article
Closed access
DLDavid López
David López
RMRoberto Marivela
Roberto Marivela
Luis GarroteLuis Garrote
Luis Garrote
The capability of Smoothed Particle Hydrodynamics (SPH) to reproduce a mobile hydraulic jump was investigated.A similar case was used to generate different upstream Froude numbers to obtain several jump shapes. A physical model was then constructed in a test flume to check the SPH outcomes. The results showed good agreement for Froude numbers <5. Higher Froude numbers require more sophisticated turbulence closure models to obtain better results. Good outcomes can be achieved with k-ε models, but the computational cost is higher than for basic SPH. Instead, a simple method was implemented to increase the viscosity in areas of higher vorticity. In this case, the main difference is related to the dependence of the viscosity on the vorticity. This approach yielded better adjustment. Finally, it was found that SPH provides correct estimates of the average pressures at the boundaries, but exhibits large dispersion for instantaneous water height values. This problem was considerably attenuated by introduction of a turbulence model.

1 September 2019 in Science of The Total Environment
Verified
Journal Article
Closed access
ABAlberto Rodríguez Bachiller
Alberto Rodríguez Bachiller
JRJosé Luis García Rodríguez
José Luis García Rodríguez
JSJosé Carlos Robredo Sánchez
José Carlos Robredo Sánchez
DLDavid López
David López

12 June 2023 in Water
Verified
Journal Article
Open access
PDF file
MSMarcos Sanz-Ramos
Marcos Sanz-Ramos
EBErnest Blade
Ernest Blade
NCNathalia Silva Cancino
Nathalia Silva Cancino
Fernando SalazarFernando Salazar
Fernando Salazar
DLDavid López
David López
EMEduardo Martínez-Gomariz
Eduardo Martínez-Gomariz
Off-stream reservoirs are hydraulic structures that might cause severe flood damages in case of failure or improper operation. Their safety regulations usually require hydraulic studies for flood hazard and inundation zone mapping. The selection of the break point is not trivial because the topography in its surroundings is commonly highly anthropic. A wrong selection would not provide the worst scenario in terms of maximum flood hazard extent. This work presents a probabilistic approach based on a stochastic definition of the break point along the dyke. A number of failure scenarios are generated automatically, corresponding to different breach formations. Then, an in-cascade calculation process simulates each scenario, providing a framework to carry out statistical analysis. The simulation of the breach formation and the flood wave propagation is performed through a GPU parallelised two-dimensional hydraulic numerical model, which provides a probabilistic inundation zone and flood hazard mapping of all scenarios simulated in a suitable timeframe.

30 April 2025 in Ingeniería del Agua
Verified
Journal Article
Open access
PDF file
MSMarcos Sanz-Ramos
Marcos Sanz-Ramos
ESEsteban Sañudo
Esteban Sañudo
DLDavid López
David López
Orlando Garcia-FealOrlando Garcia-Feal
Orlando Garcia-Feal
EBErnest Blade
Ernest Blade
Luis CeaLuis Cea
Luis Cea
Iber es una herramienta de simulación hidráulica bidimensional surgida desde la academia para dar solución a problemas de ingeniería hidráulica y ambiental. Desde su nacimiento en 2010 se ha convertido en un software ampliamente aceptado para simular procesos hidrodinámicos de flujo en lámina libre. Este trabajo presenta la evolución de Iber y analiza las mejoras llevadas a cabo que actualmente permiten realizar simulaciones, completamente acopladas con la hidrodinámica, de transporte de sedimentos y calidad de aguas, de procesos hidrológicos a nivel de cuenca rural y urbana, de eco-hidráulica, etc. Los módulos y capacidades de cálculo implementados, así como las líneas de trabajo futuras, demuestran que la modelización hidrodinámica bidimensional todavía tiene un gran margen para el desarrollo de nuevas aplicaciones y mejoras. Iber sigue unas líneas de desarrollo con un enfoque eminentemente práctico, permitiendo a usuarios y usuarias realizar simulaciones cada vez más fidedignas al proceso físico a representar.

20 March 2019 in Water
Verified
Journal Article
Open access
PDF file
JRJuan José Rebollo
Juan José Rebollo
DLDavid López
David López
Luis GarroteLuis Garrote
Luis Garrote
TRTamara Ramos
Tamara Ramos
RDRubén Díaz
Rubén Díaz
RHRicardo Herrero
Ricardo Herrero
Energy dissipation structures play an important role in flood risk management. Many variables need to be considered for the design of these structures. Aeration has been one of the more studied phenomena over the last years, due to its influence in the performance of hydraulic structures. The purpose of the work presented in this article is to experimentally characterize the effects of aeration on boundary friction in supercritical and fully turbulent flows. The physical model used to analyze the aeration effects consists of a spillway chute 6.5 m high and a stilling basin of 10 m length and 2 m high. A pump and compressor supply the water-air mixture and are controlled at the entrance by valves and flowmeters. The ensuing channel is monitored to determine the velocity profile and air concentration of the flow into the stilling basin. The average values of both variables and Manning’s coefficient along the channel are used to determine the relation between air concentration and energy dissipation by friction. A velocity increase with greater air entrainment has been found in all scenarios since friction is the main energy dissipation mechanism in open channels flow. Finally, an equation is proposed to characterize this evolution based on the results obtained.

31 January 2024 in Ingeniería del Agua
Verified
Journal Article
Open access
PDF file
DLDavid López
David López
MBMiguel De Blas-Moncalvillo
Miguel De Blas-Moncalvillo
VCVicente Cuéllar-Moro
Vicente Cuéllar-Moro
La sedimentación del embalse de Marmolejo incrementa el riesgo de inundación en el Municipio de Andújar (Jaén, España) situado en la cola del embalse. La administración hidráulica española ha diseñado una serie de medidas de protección cuya efectividad queda condicionada al nivel de sedimentación del embalse. Con la información batimétrica y de aforos de sedimentos en suspensión se ha calculado la ley de aportación de sedimentos al embalse. Ha sido necesario el empleo de técnicas de supercomputación y machine learning, así como un nuevo modelo de transporte de sedimento en suspensión, para calibrar un modelo numérico bidimensional del embalse, que ha permitido reproducir la evolución histórica del proceso de sedimentación. Finalmente se ha desarrollado una herramienta web que simula la sedimentación en el embalse en función del criterio de gestión de compuertas, a fin de optimizar la explotación del embalse y mantener la sedimentación en niveles de seguridad para Andújar.