This study experimentally determines the wind loads on a stand-alone solar array (length-to-width ratio of 0.19; 1/10-scale commercial modules). The freestream velocity in a uniform flow is 14.5 ± 0.1 m/s, and the turbulence intensity is 0.3%. The angle of tilt ranges from 10° to 80° and the wind is incident at angle of 0°–180°. Mean surface pressure measurements on the upper and the lower surface of the inclined solar panels are used to calculate the lift coefficient. For the angle of incidence of 0°–60° for the wind, the variation in the lift coefficient with the angle of tilt is U-shaped. The formation of a strong windward corner vortex results in greater lift force on the right half of the inclined plate for the angle of incidence of 30°–45° for the wind.
Flow past a single-line arrangement of evenly-spaced row trees, in an open territory, was numerically simulated under the action of a boundary-layer type of oncoming flow, with a strength of “strong breeze”, based on the Beaufort scale. By selecting Koelreuteria henryi as the demonstrated tree species, the spatial wind speed variations behind row trees at the pedestrian level, at various tree heights and tree spaces, were analyzed to investigate the corresponding downstream shelter effects from a systematic basis. Based on the results of the analyses, the tendency of stream-wise wind speed variations behind the row trees was presented so as to provide additional insights into row-tree planning for protection against ground wind. Moreover, in other cases of row trees with similar crown shapes and properties, resulting flow fields for various tree heights and tree spaces can provide referable quantitative information, which can be readily used to conduct tentative shelter effect assessments and pedestrian comfort evaluations in a preliminary planning stage.
12 April 2021 in Journal of the Chinese Institute of Engineers
A scaffolding system model at one side of the exterior surfaces of a square building was set in the wind tunnel to measure the wind forces on the system in various oncoming-flow directions. The scaffolding system with additional clad sheets at three porosity ratios was tested to examine its wind load effect. Moreover, numerical computations were performed to examine the wind flow in the region between the building surface and the impermeable clad sheet. Results show that a decrease of screen porosity generally promotes varies wind force with the oncoming-flow direction variation. As the scaffolding system is at the windward side of the building, a maximum total push-in force occurs. When the system is parallel to the oncoming-flow direction, the total pull-out force becomes maximum. The cross-sectional maximum and minimum net pressure values mostly occur near the edge or the corner of the scaffolding system. Among all oncoming-flow directions, finally, cross-sectional large wind speeds usually occur at the upstream upper corner in the scaffolding system. The most critical situation that endangers the safety of construction workers due to the occurrence of local gust wind can happen when the oncoming-flow direction angle is within the range of 60 to 90 degrees.
This study determines the lift force on a tilted solar PV panel with/without side plates (upward and downward types). The tilt angles are 15° and 30° and the wind incidence is at an angle of 0–180° (in increments of 15°). Measurements of mean surface pressure are conducted in a closed-loop wind tunnel. The corner vortices are lessened with the presence of upward or downward side plates for the wind angle of incidence of 0°. The mean surface pressure on the lower surface with downward side plates is more positive (greater wind loads). With upward side plates, there is less suction on the upper surface near the windward corner for the wind angle of incidence from 15° to 60°, resulting in significantly reduced wind loads.
The adverse effect of crosswinds on road vehicles on a bridge deck or traffic lanes is of increasing concern. Local flow characteristics depend on the bridge's architecture and wind barriers (WBs) are commonly used to alleviate wind-induced instability for vehicles. Terrain orography is another dominant factor. This study uses a terrain model with a coastal bridge (Chen-Kung Bridge, Penghu, Taiwan). The bridge is located between a reservoir and the Taiwan Strait. Numerous accidents have occurred due to strong monsoon winds in autumn and winter. In wind tunnel experiments, an atmosphere boundary layer is established and the test conditions (wind speed and wind incidence) are taken from local meteorological data. The effect of the height of solid WBs on local wind direction and speed is determined. The results can be used to remodel WBs to increase safety for road vehicles.
This study experimentally investigates the wake dynamics of a two-dimensional square cylinder with dual rigid splitter plates (DRSP) of varying spanwise widths (W/D = 2–∞) at Re = 1.2 × 105. Splitter plates are used for wake stabilization but most studies vary the length and consider the spanwise extent to be infinite, so the three-dimensional effects of a finite-width DRSP—and the resulting edge-induced flow structures are not well understood. This study uses time-resolved particle image velocimetry (TR-PIV) to measure the instantaneous velocity field in the near-wake region and proper orthogonal decomposition (POD), spectral analysis, and vorticity-based flow visualization. The mean streamwise velocity fields feature a deepening of the wake velocity deficit as W/D increases, and there is an increase in the lateral extent. Narrower plates promote a more rapid wake recovery, but wider configurations (W/D ≥ 8) create a deeper and more persistent velocity deficit. The distributions of streamwise and spanwise velocity fluctuations are progressively reduced as W/D increases to a limit if W/D = ∞, at which point, large-scale wake motions are most effectively damped. Turbulent kinetic energy features a similar monotonic attenuation, which shows that there is progressive inhibition of shear–layer interactions as lateral confinement increases. POD analysis shows that there is a consistent modal structure for all cases: Modes 1 and 2 form a classical antisymmetric vortex-shedding pair, and higher-order modes feature lower-energy, less coherent flow structures in the wake. The shape of the mode remains qualitatively similar, but the associated modal energies decrease as W/D increases, which shows that global instability decreases. Spectral analysis of the POD temporal coefficients shows that distinct second and third harmonics (2f1 and 3f1) are present for the W/D = 2 configuration. For intermediate DRSP widths (W/D = 4–8), these harmonic components do not occur, but there is an additional dominant frequency (f2). As the DRSP width increases (W/D = 10 and ∞), the spectra exhibit broadened frequency peaks, which show that there is a loss of discrete harmonic content in the wake dynamics. Instantaneous vorticity fields show that the wake structure evolves continuously and there is no abrupt transition: narrow DRSP widths permit sustained shear–layer communication, but increasing DRSP width progressively leads the wake toward the limiting behavior of an idealized infinite DRSP configuration (W/D = ∞). This is characterized by increased symmetry and the formation of larger, more coherent vortex structures associated with elongated shear–layer development. Increasing W/D progressively weakens the temporal organization of vortex shedding and delays the development of strong shear–layer interactions. As a result, wake unsteadiness is redistributed rather than uniformly suppressed, leading to a continuous and quantifiable transition from strongly interacting near wakes toward a state characterized by weakened shear–layer interaction and an asymptotic wake response at sufficiently large W/D.