The paper introduces Smart Grids and the methodology for the selection of ICT technologies for them. It describes the quality and implementation-operating parameters for evaluation ICT technologies and services and applications running in Smart Grids. The methodology is based on a comparison of these parameters. This methology is also based on the availability and reliability of ICT technologies. Selection of ICT technologies is demonstrated at the end of the paper.
24 September 2013 in Advances in Electrical and Electronic Engineering
Passive optical networks (PONs) represent a promising solution for modern access telecommunication networks. These networks are able to meet the increasing demands on transmission rate for demanding multimedia services, while they can offer typical shared transmission speed of 1.25 or 2.5 Gbps. The major role in deploying optical distribution networks ODNs plays the maximum attenuable loss, which is caused mainly by passive optical splitters. This paper proposes an innovative application of passive optical networks with optimized bus topology especially for local backbone data networks. Due to using only passive components, it is necessary to optimize certain parameters, especially an overall attenuation balance. Considering the possibility of such optimization, the passive optical network with optimized bus topology provides several interesting opportunities for specific applications. This paper will present selected aspects of passive optical networks and splitters with asymmetric splitting ratio. The essential part is focused on the practical demonstration of their use to optimize the passive optical network with bus topology, which acts as a local backbone network for structured cabling systems, and for local data networks in large buildings.
The digital subscriber lines with very high speed data rates combined together with passive optical networks are considered as a promising high-speed solution for modern metallic and hybrid access networks. To increase the transmission capacity in such case, it would be possible to implement an idea of using multiple pairs of local cables and group them together using an inverse multiplexing technique. This article first introduces the basic parameters of broadband measurements of phantom circuit created from pairs within one star-quad, together with the description of method for far-end crosstalk modeling. Based on these results, a practical experiment was performed using real metallic cable. The next part is focused on the simulation of digital subscriber line using phantom circuit together with and without crosstalk elimination technique using vector multi-tone modulation. The results and calculations of possible transmission capacity of phantom circuit are compared with measured results.