Magnetic resonance imaging visualization down to nanometric liquid films in model porous media with pore sizes from micro- to nanometers enables one to fully characterize the physical mechanisms of drying. For pore size larger than a few tens of nanometers, we identify an initial constant drying rate period, probing homogeneous desaturation, followed by a falling drying rate period. This second period is associated with the development of a gradient in saturation underneath the sample free surface that initiates the inward recession of the contact line. During this latter stage, the drying rate varies in accordance with vapor diffusion through the dry porous region, possibly affected by the Knudsen effect for small pore size. However, we show that for sufficiently small pore size and/or saturation the drying rate is increasingly reduced by the Kelvin effect. Subsequently, we demonstrate that this effect governs the kinetics of evaporation in nanopores as a homogeneous desaturation occurs. Eventually, under our experimental conditions, we show that the saturation unceasingly decreases in a homogeneous manner throughout the wet regions of the medium regardless of pore size or drying regime considered. This finding suggests the existence of continuous liquid flow towards the interface of higher evaporation, down to very low saturation or very small pore size. Paradoxically, even if this net flow is unidirectional and capillary driven, it corresponds to a series of diffused local capillary equilibrations over the full height of the sample, which might explain that a simple Darcy's law model does not predict the effect of scaling of the net flow rate on the pore size observed in our tests.
From observations of the progressive deposition of noncolloidal particles by geometrical exclusion effects inside a 3D model porous medium, we get a complete dynamic view of particle deposits over a full range of regimes from transport over a long distance to clogging and caking. We show that clogging essentially occurs in the form of an accumulation of elements in pore size clusters, which ultimately constitute regions avoided by the flow. The clusters are dispersed in the medium, and their concentration (number per volume) decreases with the distance from the entrance; caking is associated with the final stage of this effect (for a critical cluster concentration at the entrance). A simple probabilistic model, taking into account the impact of clogging on particle transport, allows us to quantitatively predict all these trends up to a large cluster concentration, based on a single parameter: the clogging probability, which is a function of the confinement ratio. This opens the route towards a unification of the different fields of particle transport, clogging, caking, and filtration.
For most wood-based product uses it is essential to remove a large part of the water content from wet or green (fresh-cut) wood, to reduce further dimensional variations under varying humidity conditions, improve its mechanical characteristics, and protect it from biological attacks. However, the internal mechanisms of drying are not fully described. Here we observe drying at different scales using macroscopic measurements (weighing), nuclear magnetic resonance measurements allowing to distinguish bound- and free-water contents, and x-ray computed tomography images of air-liquid interfaces at the smallest pore scale (wood lumens). We show that during wood drying, even well above the fiber saturation point, bound-water diffusion in cell walls (instead of capillary effects) ensures the extraction of liquid water from pores and its transport towards the surface of evaporation, and thus controls the drying rate. The distribution of bound-water content (uniform or heterogeneous) along the main sample axis and the drying-rate evolution depend on the competition between the external conditions and a characteristic rate of transport due to bound-water diffusion. For sufficiently slow drying this distribution remains homogenous until free water is fully extracted. An original physical phenomenon is thus at work, which plays a major role in regulating water extraction, in that it maintains a constant drying rate and a homogeneous distribution of the (mean) water content throughout the material. These results provide sound concepts for modeling and controlling drying properties of wood materials. They open the way to the understanding or control of the properties of many other materials containing two water types in food or civil-engineering applications. Our results complete recent observations that bound-water diffusion also controls imbibition in hardwood and finally show that transfers between bound and free water play a major role in the interaction of plantlike systems with water.