Global Navigation Satellite System (GNSS) reflected signals can be used to remotely sense the Earth’s surface, known as GNSS reflectometry (GNSS-R). The GNSS-R technique has been applied to numerous areas, such as the retrieval of wind speed, and the detection of Earth surface objects. This work proposes a new application of GNSS-R, namely to detect objects above the Earth’s surface, such as low Earth orbit (LEO) satellites. To discuss its feasibility, 14 delay Doppler maps (DDMs) are first presented which contain unusually bright reflected signals as delays shorter than the specular reflection point over the Earth’s surface. Then, seven possible causes of these anomalies are analysed, reaching the conclusion that the anomalies are likely due to the signals being reflected from objects above the Earth’s surface. Next, the positions of the objects are calculated using the delay and Doppler information, and an appropriate geometry assumption. After that, suspect satellite objects are searched in the satellite database from Union of Concerned Scientists (UCS). Finally, three objects have been found to match the delay and Doppler conditions. In the absence of other reasons for these anomalies, GNSS-R could potentially be used to detect some objects above the Earth’s surface.
6 March 2020 in IEEE Transactions on Geoscience and Remote Sensing
Global Navigation Satellite System Reflectometry (GNSS-R) altimetry uses GNSS-reflected signals off a water body to measure the height of the reflecting surface. The maximum value of the leading-edge derivative (LED) is an important path delay estimator in GNSS-R altimetry. The LED assumes that the weight function representing the power contribution per unit delay is monotonically decreasing with delay. This article focuses on the validation of the LED in space-based GNSS-R altimetry. Two problems of the weight function were studied. First, the monotonicity condition that the weight function requires to meet was theoretically analyzed, reaching the conclusion that the weight function needs to be monotonically nonincreasing. Second, whether the weight function could meet the monotonicity condition was simulated using the orbits of the COSMIC, GRACE, and GPS satellites, and the antenna gain map of the TechDemoSat-1 (TDS-1) mission. Results showed that the monotonicity of the weight function is largely dominated by Doppler, and meets the monotonicity condition because over 97% events decrease with delay. Antenna gain is the only factor that may disobey the monotonicity condition, but has no significant impact on the monotonicity of the weight function for this article. Therefore, the LED is valid for space-based GNSS-R altimetry as studied in this article.
1 May 2019 in IEEE Journal of Selected Topics in Applied Earth Observations and Remote Sensing
It is a challenge to achieve high accuracy altimetric results using space-based global navigation satellite system reflectometry (GNSS-R). This paper focuses on improving the accuracy of space-based GNSS-R altimetric measurements by considering receiver dynamics in the geometric model. The receiver dynamics has negligible impact on the geometric model of low-platform GNSS-R because the receiver movement is quite small during the time period between receiving direct and reflected signals. However, in the case of space-based GNSS-R, the receiver has much higher dynamics, thus the receiver dynamics cannot be ignored. This paper analyzes the altimetric error caused by the receiver dynamics in space-based GNSS-R. Theoretical studies and simulations were conducted to evaluate the magnitude of the altimetric error caused by receiver dynamics. The results show that the dynamics of a low earth orbit receiver can lead to errors of the order of several meters, depending on the trajectory angle of the receiver. The results using data from the TDS-1 mission conclude that neglecting receiver motion causes an average error of 3.4 m. This agrees with the result obtained from a theoretical analysis. Therefore the geometric model that takes into account receiver dynamics can improve the accuracy of space-based GNSS-R altimetric measurements of the order of a few meters compared to neglecting receiver dynamics.