The objective of the studies presented in this paper was to understand the transient response of thick circular and square bars subjected to transverse elastic point impact. It is shown that the transient response is composed of a number of resonant frequencies caused by cross-sectional modes of vibration. The individual cross-sectional modes and their corresponding natural frequencies were determined using plane strain and three-dimensional finite-element models of circular and square cross sections. The first few modes for both circular and square cross sections are shown. Subsequently, three-dimensional finite-element models of circular and square bars were used to determine the transient response caused by transverse point impact. To verify the results obtained from the numerical models, experimental studies were performed on a 0.4-m-diam circular bar and a 0.3-m square bar. These specimens were representative of full-size concrete columns—typical barlike structural elements. The results of these experimental studies were in excellent agreement with those obtained from the finite-element analyses. A future paper will present the results obtained from numerical and experimental studies on rectangular bars.
Numerical and experimental studies of the transient response of concrete shafts subjected to elastic impact were carried out using the finite element method and the impact-echo testing technique. Two- and three-dimensional finite element studies of concrete shafts were performed for: (a) solid shafts; (b) shafts containing cracks, voids, layers of low-quality concrete, and changes in cross section, such as bulges and necks; and (c) shafts in soil. These studies were carried out to gain an improved understanding of the impact response of concrete shafts containing flaws, problems for which there are currently no analytical solutions. It was also the intent of the numerical studies to determine whether information in addition to that obtained with existing nondestructive testing techniques could be obtained during impact testing of concrete shafts. Laboratory studies of solid concrete shafts were carried out to verify the finite element models. Subsequently, experimental studies were carried out on concrete shafts embedded in soil. These shafts contained flaws at known locations. The results of these studies show that additional information about the integrity of drilled shafts and piles can be obtained using impact techniques. The numerical studies also show that the finite element method is a powerful tool for studying the impact response of concrete foundation elements.
1 March 1990 in Journal of Nondestructive Evaluation
This paper presents experimental results of 44 composite beam structures tested under static and fatigue loads. While designing the specimens, variables considered included: (1) the number of shear studs; (2) reinforcing method (deformed bars versus welded wire fabric); and (3) load levels and load ranges for fatigue tests. Results show that (1) cracks were initiated in the concrete slab; (2) propagation and connection of cracks led all specimens to fail; (3) the shear studs become stressed after formation of the cracks; (4) crushing of concrete near the shear studs was observed in some fatigue tests; and (5) the flexural stiffness of the specimens decreased through fatigue tests. The specimens containing wire mesh are superior to those containing steel bars. Moreover, no practical difference in structural behavior was found between the full composite and the 80% composite specimens.