The structural design of nanosized electrocatalysts is extremely important for cathodic oxygen reduction reactions (ORR) and anodic oxidation reactions in small organic compounds in direct fuel cells. While Pt is still the most commonly used electrode material for ORR, the Pd electrocatalyst is a promising alternative to Pt, because it exhibits much higher electrocatalytic activity towards formic acid electrooxidation, and the electrocatalytic activity of ORR on the Pd electrode is the higher than that of all other precious metals, except for Pt. In addition, the mass activity of Pt in a core–shell structure for ORR can be improved significantly by using Pd and Pd-based materials as core materials. Herein, we review various nanoscale Pd-based bimetallic, trimetallic and core–shell electrocatalysts for formic acid oxidation and ORR of polymer electrolyte fuel cells (PEFCs). This review paper is separated into two major topics: the electrocatalytic activity towards formic acid oxidation over various Pd-based electrocatalysts, and the activity of ORR on Pd-based materials and Pd core–Pt shell structures.
FE towards formation of formic acid over Cu 6 Sn 5 core–Sn oxide shell structure was higher than that of Sn plate and Sn NP/CB. We believe that the key factor affecting the high selectivity is a compressive strain of surface.
Recently a water-based polymer binder has been getting much attention because it simplifies the production process of lithium ion batteries (LIBs) and reduce their cost. The surface of LiNiaCobAl1−a−bO2 (a > 0.85, NCA) cathode with a high voltage and high capacity was coated doubly with water-insoluble titanium oxide (TiOx) and Li2CO3 layers to protect the NCA surface from the damage caused by contacting with water during its production process. The TiOx layer was at first coated on the NCA particle surface with a tumbling fluidized-bed granulating/coating machine for producing TiOx-coated NCA. However, the TiOx layer could not coat the NCA surface completely. In the next place, the coating of the TiOx-uncoated NCA surface with Li2CO3 layer was conducted by bubbling CO2 gas in the TiOx-coated NCA aqueous slurry on the grounds that Li2CO3 is formed through the reaction between CO32− ions and residual LiOH on the TiOx-uncoated NCA surface, resulting in the doubly coated NCA particles (TiOx/Li2CO3-coated NCA particles). The Li2CO3 coating is considered to take place on the TiOx layer as well as the TiOx-uncoated NCA surface. The results demonstrate that the double coating of the NCA surface with TiOx and Li2CO3 allows for a high water-resistance of the NCA surface and consequently the TiOx/Li2CO3-coated NCA particle cathode prepared with a water-based binder possesses the same charge/discharge performance as that obtained with a “water-uncontacted” NCA particle cathode prepared using the conventional organic solvent-based polyvinylidene difluoride binder.