Double-layer magnetoelectric (PZT) nanocomposite thin film was prepared via a pulsed-laser deposition. X-ray diffraction showed that there are no other phases but PZT and CFO phases in the film. The smooth film surface was obtained after depositing the CFO and PZT layers. The double-layer thin film exhibits both good ferromagnetic and electric properties, as well as a magnetoelectric coupling effect. The magnetic-field-induced polarization in the thin film is zero below the dc magnetic field of and keeps constant above , and is strongly dependent on the ac magnetic field frequency which drives the magnetic domain rotation and then the electric polarization in the PZT layer.
Multiferroic laminated composites of were prepared by conventional ceramic processing. The interdiffusion of the elements between different layers occurred, altering material properties. The dielectric behavior of such a sandwiched ceramic was dominated by the relative thickness of the different layers because of the high dielectric constant of the PZT layer and the low dielectric constant of the CFO layer. The magnetoelectric behaviors were strongly dependent on the relative thickness of the CFO layer, dc magnetic field, ac magnetic frequency, and the angle between the magnetic field and polarization direction. The maximal magnetoelectric-induced voltage coefficient of the composites reaches up to about , close to what was reported previously. The magnetoelectric effect of the laminated composites was also simulated with the finite-element method. The reasons for the difference between experiment and simulation were discussed.
1 March 2016 in Journal of Magnetism and Magnetic Materials
NiFe2O4@BaTiO3 multiferroic composite particles were produced by a simple hydrothermal method in two steps: preparing NiFe2O4 nanoparticles and then synthesizing core-shell nanocomposites. Multiferroic composite ceramics were sintered from these powders. X-ray diffraction, Raman scattering and energy dispersive x-ray analyses indicated that the core-shell composites with a NiFe2O4 core and BaTiO3 shell were formed in the hydrothermal environment. Different types of sharp interfaces were self-assembled owing to the minimization of direct elastic energy. The saturation magnetization of the composites linearly increased with the NiFe2O4 content while the dielectric constant decreased. A dielectric peak appeared at around 460 °C because of the oxygen vacancies in the BaTiO3 ceramics. It resulted in an enhancement of magnetic permeability in the composites, indicating magnetoelectric coupling that was also observed by direct magnetoelectric measurements.
4 November 2023 in Applied Catalysis B: Environment and Energy