Lipophilicity is one of the principal parameters that describe the pharmacokinetic behavior of a drug, including its absorption, distribution, metabolism, elimination, and toxicity. In this study, the lipophilicity and other physicochemical, pharmacokinetic, and toxicity properties that affect the bioavailability of newly synthesized dialkylaminoalkyldiquinothiazine hybrids as potential drug candidates are presented. The lipophilicity, as R_M0, was determined experimentally by the RP-TLC method using RP18 plates and acetone–TRIS buffer (pH 7.4) as the mobile phase. The chromatographic parameters of lipophilicity were compared to computationally calculated partition coefficients obtained by various types of programs such as iLOGP, XLOGP3, WLOGP, MLOGP, SILCOS-IT, LogP, logP, and milogP. In addition, the selected ADMET parameters were determined in silico using the SwissADME and pkCSM platforms and correlated with the experimental lipophilicity descriptors. The results of the lipophilicity study confirm that the applied algorithms can be useful for the rapid prediction of logP values during the first stage of study of the examined drug candidates. Of all the algorithms used, the biggest similarity to the chromatographic value (R_M0) for certain compounds was seen with iLogP. It was found that both the SwissADME and pkCSM web tools are good sources of a wide range of ADMET parameters that describe the pharmacokinetic profiles of the studied compounds and can be fast and low-cost tools in the evaluation of examined drug candidates during the early stages of the development process.

This work presents an overview of the modern approaches embracing advanced equipment and validation parameters of both liquid and gas chromatography techniques, including thin-layer chromatography (TLC), column liquid chromatography (CLC), and gas chromatography (GC), suitable for the identification and quantitative determination of various bioactive compounds occurring in pharmaceutical products and medicinal plants in the time from 2020 to 2021 (November). This review confirmed that HPLC is an incredibly universal tool, especially when combined with different detectors, such as UV-Visible spectroscopy, mass spectrometry (MS), and fluorescence detection for numerous active ingredients in different pharmaceutical formulations without interferences from other excipients. TLC, in combination with densitometry, is a very efficient tool for the determination of biologically active substances present in pharmaceutical preparations. In addition, TLC coupled to densitometry and mass spectrometry could be suitable for preliminary screening and determination of the biological activity (e.g., antioxidant properties, thin layer chromatography (TLC) by 2,2-diphenyl-1-picrylhydrazyl (DPPH) method) of plant materials. Gas chromatography, coupled with a mass spectrometer (GC-MS, GC-MS/MS), is of particular importance in the testing of any volatile substances, such as essential oils. LC, coupled to NMR and MS, is the best solution for identifying and studying the structure of unknown components from plant extracts, as well as degradation products (DPs). Thanks to size-exclusion chromatography, coupled to multi-angle light scattering, the quality control of biological pharmaceuticals is possible.

This review presents various chromatographic systems, TLC, HPLC, GC, and also SFC, developed for identification and accurate quantification of long‐chain mono‐ and polyunsaturated fatty acids from different samples with emphasis on selected literature which was published during last decade. Almost all the aspects such as preseparation step of fatty acids ( cis and trans ), stationary phase, solvent system, and detection mode are discussed.

Lipophilicity in addition to the solubility, acid-base character and stability is one of the most important physicochemical parameters of a compound required to assess the ADMET properties (absorption, distribution, metabolism, excretion and toxicity) of a bioactive molecule. Therefore, the subject of this work was to determine the lipophilicity parameters of selected antimicrobial and immunosuppressive compounds such as delafloxacin, linezolid, sutezolid, ceftazidime, everolimus and zotarolimus using thin-layer chromatography in reversed phase system (RP-TLC). The chromatographic parameters of lipophilicity (R_MW) for tested compounds were determined on different stationary phases: RP18F₂₅₄, RP18WF₂₅₄ and RP2F₂₅₄ using ethanol, acetonitrile, and propan-2-ol as organic modifiers of mobile phases used. Chromatographically established R_MW values were compared with partition coefficients obtained by different computational methods (AlogPs, AClogP, AlogP, MlogP, XlogP2, XlogP3, logP_KOWWIN, ACD/logP, milogP). Both cluster and principal component analysis (CA and PCA) of the received results allowed us to compare the lipophilic nature of the studied compounds. The sum of ranking differences analysis (SRD) of all lipophilicity parameters was helpful to select the most effective method of determining the lipophilicity of the investigated compounds. The presented results demonstrate that RP-TLC method may be a good tool in determining the lipophilic properties of studied substances. Obtained lipophilic parameters of the compounds can be valuable in the design of their new derivatives as efficient antimicrobial and immunosuppressive agents.

Adsorption thin layer chromatography (NP-TLC) with densitometry has been established for the identification and the quantification of acetaminophen in three leading commercial products of pharmaceutical tablets coded as brand: P1 (Productno. 1), P2 (Productno. 2), and P3 (Productno. 3). Applied chromatographic conditions have separated acetaminophen from its related substances, namely, 4-aminophenol and and 4′-chloroacetanilide. UV densitometry was performed in absorbance mode at 248 nm. The presented method was validated by specificity, range, linearity, accuracy, precision, detection limit, quantitative limit, and robustness. The TLC-densitometric method was also compared with a pharmacopeial UV-spectrophotometric method for the assay of acetaminophen, and the results confirmed statistically that the NP-TLC-densitometric method can be used as a substitute method. It could be said that the validated NP-TLC-densitometric method is suitable for the routine analysis of acetaminophen in quantity control laboratories.