We demonstrate using theoretical analysis and full wave numerical simulations nondiffracting circular Airy beams modulated with different orbital angular momenta (OAM) at mm wavelengths. It is shown that applying an azimuthal spiral phase component to the circular Airy beam results in a circular Airy OAM beam. These beams are radially symmetric with a null at the center and experience an inward radial shift within a certain propagation distance. Such propagation dynamics are contrary to that of a conventional OAM beam where the vortex radius increases and the beam intensity decreases as the beam propagates due to diffraction effects. Thus, the circular Airy OAM beam can be nondiffracting over an appreciable distance of few tens of meters (i.e. few thousand wavelengths) and open the door for high data rate communications. Phase only spatial wave modulators of aperture 20 cm × 20 cm with 40 × 40 pixels are designed for generating the circular Airy OAM beams with OAM of order 0, 1 and 2. These spatial wave modulators when illuminated with Gaussian beams generate the corresponding circular Airy OAM beam. Full wave numerical simulation results showing the generation and propagation of circular Airy OAM beams at mm wavelengths that are nondiffracting up to 50 m are presented.
This paper proposes a Doppler detection method for Linear FM (LFM) waveform by identifying its location within the extended Matched Filter (MF). The extended MF of a LFM waveform is constructed by extending its frequency sweep on both sides. Doppler shift results in shifting the frequency sweep of the LFM waveform along the instantaneous frequency of its extended MF. Thus, identifying the location of the received LFM waveform within its extended MF results in detecting the Doppler shift of the LFM waveform. At the receiver, after carrier demodulation the highly sampled received signal is first passed into the extended MF. Timing of the mainlobe of the extended MF output is used to identify the highly sampled received signal containing the LFM waveform within the extended MF. Then, a running sum of these samples over a length equal to that of the highly sampled LFM waveform is computed. The maximum of this running sum occurs at the location of the LFM waveform within the extended MF which in turn results in identifying its Doppler shift. In comparison with the method of Doppler detection using a triangular FM waveform, it is shown that the proposed method has superior performance in the presence of additive noise.
This paper comprehensively overviews the various techniques of generating Orbital Angular Momentum (OAM) beams from microwave to optical frequencies for wireless communications applications. OAM communications has been explored extensively over the past two decades for its potential to improve spectral efficiency and increase capacity. This review paper broadly categorizes the different generation techniques into active and passive methods. Active methods include arrays of actively excited radiating antenna elements that offer dynamic control over the phase profile, enabling real-time manipulation of OAM beams. Additionally, the mutual coupling between antenna elements in uniform circular arrays is discussed, as it can significantly impact the performance and purity of OAM beams, and strategies to mitigate these effects are explored. Passive methods include spiral phase plates, reflect arrays, metasurfaces, optical rectification, difference frequency generation, laser plasma, discrete dielectric lenses, etc., which utilize static elements to manipulate the phase of an incident plane wave and create a helical phase front characteristic of an OAM wave. The paper discusses each method’s principle, advantages, and challenges, highlighting their potential applications primarily in wireless communication and additionally in optical information processing and radar. The paper also discusses methods for achieving high mode purity, which is essential for reliable OAM mode identification and efficient separation of multiplexed OAM beams. Techniques for multiplexing several OAM modes, such as concentric circular arrays considering the cross-coupling effects and mitigation methods, Butler matrices, MIMO techniques, and enhancing OAM beam propagation using lenses and superposition with non-diffracting beams, are also discussed.
This paper proposes novel nonlinear mismatched filters for classes of aperiodic codes. They are constructed by combining one or more matched filter outputs additively and multiplicatively. The final output has just the mainlobe and zero sidelobes. The proposed mismatched filters do not widen the mainlobe and incur little additional delay. When combined with subchip encoding, which is proposed in this paper as an alternative to the regular sinusoidal chip, the mainlobe width is reduced. This improves range resolution in radar applications and timing and synchronization precision in communications applications.
In this paper, a new code is constructed by concatenating a Golay complementary code pair (A, B) with a gap in between. The autocorrelation of this code contains a zero-sidelobe region on either side of the mainlobe and an adjacent region of small cross-correlation sidelobes. This is achieved by using a polyphase code pair as chips for A and B that satisfy two conditions: they have conjugate symmetry/anti-symmetry property and are quasi-orthogonal in the convolution sense. The conjugate symmetry/anti-symmetry property results in the zero-sidelobe region, while the quasi-orthogonality property makes the adjacent region of cross-correlation sidelobes small. The complementary code pair could also be interlaced in the time domain avoiding the above mentioned gap. However, the zero-sidelobes and the small cross-correlation sidelobes are also interlaced in its autocorrelation. Polyphase codes based on linear FM (LFM) and piecewise LFM (PLFM) waveforms are used as chips for the complementary code pair, since they satisfy both the conjugate symmetry/anti-symmetry and the quasi-orthogonality conditions. Any polyphase good code set that satisfies the conjugate symmetry/anti-symmetry condition could be used as chips with the same complementary code pair to generate a good code set with a zero-sidelobe region and an adjacent region of small cross-correlation sidelobes. Such sets are constructed using polyphase code sets based on LFM and PLFM waveforms as chips.
This paper introduces a good code set consisting of frequency shifted Linear FM (LFM) waveforms. It is shown that the entire set can be detected with one Smart Extended Matched Filter (SEMF), constructed by extending the frequency sweep of the LFM waveform on either side, which has an additional ability to detect the energy pattern following the multiplication of the incoming data with the filter coefficients (i.e. the Hadamard product) before the summation. This allows for associating a peak at the filter output with the location of the higher energy distribution within the filter, prior to summation. The location of this higher energy region determines the frequency shift which could identify a particular member of the proposed good code set or Doppler shift of a LFM waveform. Thus, resulting in Doppler detection for a LFM waveform or detection of a good code set comprised of frequency shifted LFM waveforms. The frequency offset between the members of the set is chosen such that Doppler shifts for individual code members could also be detectable by the SEMF. Such good code sets are generated using LFM waveforms with increasing instantaneous frequencies (or up-chirps) or LFM waveforms with decreasing instantaneous frequencies (or down-chirps) or both resulting in a larger set. However, in the case of the combined set, a receiver with two SEMF's: one for the up-chirp based set, and another for the down-chirp based set, is required.