In the present work, magnesia nanoparticles (17 nm) were synthesised by solution combustion and characterised using X‐ray diffraction and scanning electron microscopy. Nanofluid prepared by magnesia dispersion in ethylene glycol and deionised water (50:50) is characterised using Fourier transform infrared, dynamic light scattering (DLS) and Zeta potential measurement. The ‐41 mV zeta potential confirms nanofluid stability. The average particle size in the nanofluid obtained by the DLS method is 33 nm, whereas the crystallite size is 17 nm as per the Scherrer relation. The nanofluid properties were determined under varying volume concentration (0.025, 0.05, 0.1, 0.2%) and temperature (25–60°C). The viscosity measured by using a rotational viscometer decreases with increase in the temperature, whereas the thermal conductivity and specific heat, measured by using a KD2 Pro analyser and a differential scanning calorimeter, respectively, increases. With the increase in volume concentration, thermal conductivity, and viscosity increases, whereas specific heat decreases. The maximum thermal conductivity enhancement and specific heat diminution was 15.6 and 20.5%, respectively, for 0.2% concentration and the minimum viscosity was 2.2% for 0.025% concentration at 60°C. Based on the measured data, new correlations have been proposed.
This article communicates the thermal performance, heat transfer rate, and friction factor of Al2O3/DI water nanofluids at different concentrations in a micro-finned tube with tube helical inserts for different twist ratios. The thermal performance, heat transfer coefficient, and friction of the present study is also compared with a plain tube for validation. From the study, it is identified that the micro-finned tube with tube insert performance is higher as compared with a plain tube. Similarly, an empirical relation for Nusselt number (Nu) and friction factor (f) is estimated for straight twisted tube and left-right combination. The deviation between experimental and theoretical values for left-right twist and straight twist is found as 3 and 7% for Nusselt number and 7 and 9% for friction factor, respectively. Similarly, while analyzing the thermal performance, it was found that the maximum performance achieved was with a micro-fin tube with left-right twist with nanofluid concentration of 0.2%.
1 January 2019 in Experimental Thermal and Fluid Science