High-quality Ga 2 O 3 films are obtained by spray pyrolysis from aqueous solutions through optimization of the solution composition and the spraying process parameters.
The paper reports on all-solution-processed, all-oxide solar cells, based on an electrodeposited Cu2O absorber. The transparent indium-doped zinc oxide (IZO) contact and buffer layers of zinc oxide or zinc magnesium oxide (Zn1−xMgxO) were fabricated by ultrasonic spray pyrolysis. The cells were completed with graphite paste top contacts. The focus was set on using exclusively environment-friendly and low-cost raw materials, deposited from aqueous solutions without organic solvents. The latter is especially important for spray pyrolysis, where high process temperatures restrict the use of flammable solvents. The developed spray pyrolysis recipes yielded conductive (25 Ω/sq.) and transparent IZO and various compositions of transparent Zn1−xMgxO layers, with a linear dependence of the energy band gap (3.28–3.50 eV) as a function of the Mg content (0–16 mol %), as seen for layers deposited by vacuum-based techniques. Solar cells with a Zn0.88Mg0.12O buffer showed an improved photovoltaic performance compared to cells with ZnO buffer or without buffer, reaching a power conversion efficiency of 0.67% with a short-circuit current density of 3.76 mA/cm2, an open-circuit voltage of 0.34 V and a fill factor of 52.7%. The study correlated the improved cell performance with structural and electronic properties of the heterojunction.
A simple, low-temperature route for the chemical bath deposition of Mg-doped ZnO films, based on low-cost, abundant and non-toxic materials was developed. The film growth mechanism, the resulting morphology and texture were investigated in detail by scanning electron microscopy and X-ray diffraction measurements. It was found that substantial film growth is only possible in a narrow solution pH window due to the Zn(OH)2 supersaturation as driving force for the film deposition. Different amounts of Mg in the solution cause distinct (0001), (10\( \bar{1} \)0) or (10\( \bar{1} \)1) ZnO crystal textures. Speciation modelling helped to understand the solution chemistry and explain the occurrence of different textures by face-selective adsorption of Mg species onto specific ZnO faces. The amount of incorporated Mg into the ZnO lattice, determined by inductively coupled plasma atomic emission spectroscopy, was limited to 2.1 mol%. Optical band gaps, calculated from transmittance spectra, showed an increase with higher amounts of incorporated Mg and ranged between 3.41 and 3.55 eV.
This study focused on the deposition of indium-doped zinc oxide (IZO) films at high growth rates by ultrasonic spray pyrolysis. We investigated the influence of processing parameters, such as temperature and solution flow rate, on the structural, optical, and electrical film properties. For all depositions, low-cost and low-toxicity aqueous solutions and metal salt precursors were used. Through the optimization of the spraying parameters and pattern, a spatially homogeneous IZO layer with transparency greater than 80%, resistivity of 3.82 × 10−3 Ω·cm for a thickness of 1800 nm (sheet resistance of 21.2 Ω/sq), Hall carrier density of 1.36 × 1020 cm−3, Hall mobility of 12.01 cm2 V−1 s−1, and work function of 4.4 eV was obtained. These films are suitable for implementation in optoelectronic and photovoltaic devices.