A joint antenna selection and power allocation scheme is proposed for a downlink Massive multiple-input multiple-output (MIMO) system under perfect channel state information. Based on a tractable lower bound of the achievable downlink rate with linear zero-forcing precoding, a non-convex energy efficiency optimization problem is formulated with non-linear constraints. Since the optimization variables are highly interrelated, it is impractical to directly derive the closed-form solution to the original problem. To solve this problem, an effective iterative algorithm that maximizes energy efficiency is proposed according to the Lagrangian dual analysis, where the optimal number of transmit antennas and power allocation are solved alternately until convergence. Numerical results demonstrate the effectiveness of the proposed algorithm.
22 October 2019 in IEEE Transactions on Green Communications and Networking
Massive multiple-input and multiple-output (MIMO) has been recognized as a core technology for the fifth generation networks due to its huge spectral utilization brought by multiplexing gain and array gain. Most previous works on Massive MIMO systems have focused on the power optimization to maximize the system energy efficiency, in which the ergodic achievable sum-rate is replaced with a lower bound closed-form expression, which can result in suboptimal performance. In this paper, we aim to optimize the power assignment to achieve the maximum energy efficiency for a downlink system of single-cell Massive MIMO based on a tight approximate expression for the achievable sum-rate. Considering two linear precoding strategies at base station, i.e., maximum ratio transmission and zero-forcing, we first derive the corresponding approximate closed-form of the achievable sum-rate under imperfect channel state information. Furthermore, an energy-efficient power allocation scheme is formulated as a non-convex optimization problem. An iterative power allocation algorithm that maximizes the system energy efficiency is developed based on the Lagrangian dual approach. Simulation results demonstrate the tightness of the proposed approximate closed-form expressions, and show that our designed algorithm yields much better energy efficiency performance over the existing algorithms.
Direct-conversion transmitter based on the zero intermediate frequency architecture has been widely used. However, the direct current offsets (DC-offsets) introduced by the modulator affect the system performance and severely limit the calibration of IQ imbalance errors. This paper focuses on estimating and calibrating DC-offsets of modulators in the transmitter. Based on the frequency difference between the transmitted local oscillator (LO) signal and the received LO signal, the parameters of DC-offsets can be estimated by exploiting a training sequence and a self-closed loop system to achieve digital pre-compensation. The frequency response of the feedback loop and the interference introduced by the receiving channel can be ignored. There is no need to add additional hardware circuits, and the algorithm’s complexity is lower than other methods. In addition, the frequency-independent IQ imbalance errors in the transmit channel are accurately estimated. Finally, the effectiveness of the proposed algorithm is verified by simulation.
12 June 2024 in IEEE Transactions on Instrumentation and Measurement
The frequency-interleaved analog-to-digital converter (FI-ADC) can effectively improve the performance of sampling systems by expanding bandwidth and sampling rate as the number of channels increases. However, this improvement may come with drawbacks such as complex hardware requirements and potential mirror errors resulting from imbalance between in-phase and quadrature-phase signals within the system. This article proposes an alternative FI-ADC architecture, referred to as the sub-band-aliasing analog-to-digital converter (ADC). In the proposed architecture, the analog input signal is divided into multiple sub-bands, and a mixer modulates the input signal to alias adjacent sub-bands. Subsequently, the modulated signal is fed into a low-pass filter and an ADC, after which each sub-band is recovered via a recursive process involving spectrum calculation and shifting. Moreover, potential errors that may arise in practical applications are analyzed and compensated. The simulation results indicate that the proposed architecture demonstrates practical utility and can achieve comparable performance to traditional FI-ADCs while featuring a simpler architecture and a lower hardware cost. Furthermore, the effectiveness of the proposed architecture is also demonstrated by hardware experiments, in which an FI-ADC with a total bandwidth of 6GHz has been implemented using four channels, each channel having a bandwidth of only 1.5GHz.