Harvesting solar energy for artificial photosynthesis is an emerging field in alternative energy research. In this work, the photocatalytic properties of InX(X = S, Se)/transition metal disulfide (MoS2 and WS2) van der Waals heterostructures have been investigated. The calculation results indicate that these heterostructures exhibit improved photocatalytic performance over that of isolated InX or transition metal disulfide monolayers. The studied heterostructures all have type-II band alignment with holes and electrons located at the TMD and InX side, respectively. This facilitates the spatial separation of photogenerated carriers and improves the photocatalytic efficiency. The carrier mobility of the designed heterostructures can be boosted compared with the isolated monolayers, thus enhancing the carrier transport properties. Moreover, the strain-tuned heterostructures can prominently manipulate the light-harvesting capability especially from the visible light to infrared light range. Among the studied heterostructures, InSe/MoS2 with the suitable band edge positions, excellent transport properties and strain tolerance, and the lowest overpotential for oxygen evolution, stands out as the most promising candidate for photocatalytic applications. This work opens an avenue for the design of highly efficient heterostructure photocatalysts for solar-to-energy applications.
The below bandgap optical transitions of an aluminum nitride (AlN) crystal grown on a tungsten (W) substrate by physical vapor transport (PVT) are investigated by below-bandgap-excited photoluminescence (PL) spectroscopy and first-principles calculations. Oxygen (O) is the only impurity in the AlN-on-W crystal grown by PVT. By analyzing the excitation-power-, excitation-photon-energy-, and temperature-dependence of the PL spectra, the emission peaks of defect complexes involving aluminum vacancy (VAl) and substitutional oxygen (ON) with different spatial and atomic configurations, i.e., VAl–ON and VAl–2ON with ON featuring axial or basal configurations, are identified. It is revealed that two different charging states coexist in thermal equilibrium for each configuration of VAl–ON complexes. The optical transitions between the conduction band and (VAl–ON)2− and/or (VAl–2ON)1− contribute the UV emissions and those between the valence band and (VAl–ON)1− or (VAl–2ON)0 contribute the red emissions.
17 June 2019 in IEEE Journal of the Electron Devices Society
In this report, the development of physical vapor transport (PVT) methods for bulk aluminum nitride (AlN) crystal growth is reviewed. Three modified PVT methods with different features including selected growth at a conical zone, freestanding growth on a perforated sheet, and nucleation control with an inverse temperature gradient are discussed and compared in terms of the size and quality of the bulk AlN crystals they can produce as well as the process complexity. The PVT method with an inverse temperature gradient is able to significantly reduce the nucleation rate and realize the dominant growth of only one bulk AlN single crystal, and thus grow centimeter-sized bulk AlN single crystals. X-ray rocking curve (XRC) and Raman spectroscopy measurements showed a high crystalline quality of the prepared AlN crystals. The inverse temperature gradient provides an efficient and relatively low-cost method for the preparation of large-sized and high-quality AlN seed crystals used for seeded growth, devoted to the diameter enlargement and quality improvement of bulk AlN single crystals.