Spontaneous radial imbibition into thin circular samples of porous material when they have been subjected to radial temperature differences was analyzed theoretically and experimentally. The use of the Darcy equation allowed us to take into account temperature variations in the dynamic viscosity and surface tension in order to find the one-dimensional equation for the imbibition fronts. Experiments using blotting paper showed a good fit between the experimental data and theoretical profiles through the estimation of a single parameter.
The study focuses on the numerical evolution of a droplet, which hangs from a horizontal plane and moves due to thermocapillary effects. It is assumed that the liquid completely wets the substrate, that the surface tension of the liquid decreases linearly with temperature, that the imposed thermal gradient on the substrate is uniform, and that heat transport within the droplet is such that the temperature of its surface replicates that of the substrate. These assumptions, along with the lubrication approximation, allow for obtaining a differential equation that governs the evolution of the droplet. By introducing appropriate scales, this equation has a single dimensionless parameter, which expresses the ratio of gravitational to thermocapillary forces. Numerical solutions show that at sufficiently large volumes or weak thermal gradients, the droplet moves while maintaining a steady, slightly decreasing its volume, and leaving behind a tail whose width is uniform. By contrast, if the droplet is small or the thermal gradient is strong, it advances and stretches in the direction of movement.
Se investiga numéricamente la evolución de una gota cuando es depositada en el centro de un sustrato sólido, circular y plano cuya temperatura disminuye logarítmicamente con el radio. El gradiente térmico sobre el sustrato induce un gradiente de temperatura sobre la superficie del líquido, por lo que sobre esta se genera un esfuerzo de Marangoni. Dicho esfuerzo impulsa al líquido hacia la periferia del sustrato. Resultados experimentales publicados muestran que la línea de contacto avanza manteniendo inicialmente la simetría axial, pero a partir de cierto punto se desestabiliza y presenta ondulaciones que crecen con el tiempo. Con el objetivo de estudiar dicha inestabilidad, se obtienen soluciones numéricas tridimensionales de la ecuación que gobierna al fenómeno para diferentes condiciones iniciales, se detecta en cada caso la posición de la línea de contacto, y por medio de un análisis espectral se determina la evolución de cada modo normal azimutal, sus tasas de crecimiento y la posible interacción entre ellos. Para resolver numéricamente la ecuación se usó el método de elementos finitos y un esquema de diferenciación inversa con paso temporal adaptativo. Se utilizó un solver iterativo (Generalized Minimal Residuals - GMRES), preacondicionado por medio de un algoritmo multigrilla estándar MUMPS. Se utilizó un criterio de convergencia de 10−3 para el error relativo definido por una norma Euclidiana ponderada para dos iteraciones sucesivas. El dominio se discretizó con elementos triangulares no estructurados, con tamaños máximo y mínimo de 0,01 y 0,0008, respectivamente.
We study the linear stability of a droplet placed at the center of a horizontal disk under the effect of surface stress promoted by an axisymmetric thermal gradient. Since the fluid volume is constant, we solve the non-steady base flow and the perturbation simultaneously as they evolve over time. The numerical results show that the base state migrates from a droplet to a ring shape, with the front position and maximum thickness following power laws with time. The perturbations travel with the same velocity as the advancing front and develop their maxima close to the contact line. All of them initially decrease their amplitudes, later showing an increment with the growth rates depending on the wavenumber and time. The dominant wavenumber increases with time, in agreement with recent experimental work.