SnxSy films were grown by chemical spray method using aqueous solutions containing SnCl2 and SC(NH2)2 at molar ratio of Sn:S= 1:1, 1:2, 1:4 and 1:8 in the temperature interval of 200- 410°C in air. Films were characterized by XRD, SEM, EDX and UV-VIS spectroscopy. According to XRD, films grown below 270°C were composed of SnS as a main phase independent of Sn:S ratio in the parent solution. It has been shown that spray of 1:4 and 1:8 solutions results in thicker films with lower oxygen and chlorine content, and lower optical band gap compared to the films from 1:1 and 1:2 solutions
The fabrication of cost-effective photostable materials with optoelectronic properties suitable for commercial photoelectrochemical (PEC) water splitting represents a complex task. Herein, we present a simple route to produce Sb2Se3 that meets most of the requirements for high-performance photocathodes. Annealing of Sb2Se3 layers in a selenium-containing atmosphere persists as a necessary step for improving device parameters; however, it could complicate industrial processability. To develop a safe and scalable alternative to the selenium physical post-processing, we propose a novel SbCl3/glycerol-based thermochemical treatment for controlling anisotropy, a severe problem for Sb2Se3. Our procedure makes it possible to selectively etch antimony-rich oxyselenide presented in Sb2Se3, to obtain high-quality compact thin films with a favorable morphology, stoichiometric composition, and crystallographic orientation. The treated Sb2Se3 photoelectrode demonstrates a record photocurrent density of about 31 mA cm−2 at −248 mV against the calomel electrode and can thus offer a breakthrough option for industrial solar fuel fabrication.
27 March 2015 in Journal of Thermal Analysis and Calorimetry