Slips and falls are common occupational incidents worldwide. The friction on a floor surface is one of the critical environmental factors affecting the risk of a slip. In this research, we conducted friction measurements on stone and ceramic floor tiles under dry, wet, and water–detergent (WD) solution covered conditions using a horizontal pull slip meter (HPS). Our purposes were to quantify the slip resistance of commonly used stone and ceramic floors under different surface conditions and to validate the curvilinear relationship between the coefficient of friction (COF) and surface roughness of the floors proposed in the literature. The COF data were analyzed together with a surface profile parameter (Ra) of the floor samples. The results showed that the COFs of the stone floors were significantly (p < 0.0001) higher than those of the ceramic floors. All the floors under the dry conditions were slip resistant when adopting the ANSI 1264.2 criterion. Two and five ceramic floors were not slip resistant under the wet and WD solution covered conditions, respectively. Three polynomial regression equations were established to describe the relationship between the COF and Ra. The curvilinear functions of these models indicate that the three-zone (initial growth, steady-growth, and plateau) concept concerning the COF–Ra relationship in the literature was valid when static COF values measured using an HPS were adopted. In addition, the three-zone concept was valid not only on WD solution covered surfaces but also on dry and wet surfaces.
Manual material handling (MMH) tasks create a burden for workers which could result in musculoskeletal injuries. Assessments of the decrease of muscular strength and the maximum endurance time (MET) for MMH tasks are essential in studying the ergonomic risk of MMH tasks. A backpacking experiment was conducted for measuring the MET for MMH tasks. Human participants carried a load on their back and walked on a treadmill under various load, walking speed, and ramp angle conditions until they coud no longer do so. It was found that the participants were able to walk for approximately 15 min to two hours before they needed to have a pause. Their back and leg strengths declined moderately due to performing the tasks. These tasks resulted in an increase in heart rate and elevated perceived physical exertion. The rating of perceived exertion (RPE)/heart rate ratio in our backpacking tasks was 31% higher than that in the literature, implying the calibration of the RPE may be required for such tasks. A MET model incorporating the fMVC_back, body weight, walking speed, and ramp angle was established. This model may be used to determine the work/rest allowance for backpacking tasks under conditions similar to this study.