Phenol and its derivatives, which naturally occur in lignocellulose, can be considered as a renewable feedstock not only for aromatic, but also for alicyclic compounds, such as primary and N-substituted cyclohexylamines. So far, the latter are mostly produced from non-renewable starting materials like benzene via problematic nitration/reduction or cross-coupling routes. Herein, an efficient reductive amination of phenol with ammonia or amines is demonstrated, for the first time without the need for rare and expensive noble metals and without using any additives. Various supported Ni catalysts were screened and we elucidated the influence of the key parameters, including the acid–base properties of the supporting material. Acquired knowledge was then applied to different phenol–ammonia/amine combinations, resulting in the synthesis of various primary, secondary and tertiary cyclohexylamines in fair to very high yields.
Double metal cyanides (DMCs) are well known, industrially applied catalysts for ring opening polymerization reactions. In recent years, they have been studied for a variety of catalytic reactions, as well as other applications, such as energy storage and Cs sorption. Herein, a new, layered DMC phase (L-DMC), Zn2[Co(CN)6](CH3COO)·4H2O, was synthesized. The structure, which crystallizes in the monoclinic space group P21/m, consists of positively charged {Zn2Co(CN)6}+ DMC layers linked through acetate groups and presents a new layered structure to the family of double metal cyanides. L-DMC proved to be a reusable and stable catalyst that exhibited a higher activity than the benchmark DMC catalyst in two important applications: hydroamination of phenylacetylene with 4-isopropylaniline and polymerization of 1,2-epoxyhexane.
1 June 2018 in ACS Sustainable Chemistry & Engineering
Incorporation of a high density of molecular-sieving nanopores in the graphene lattice by the bottom-up synthesis is highly attractive for high-performance membranes. Herein, we achieve this by a controlled synthesis of nanocrystalline graphene where incomplete growth of a few nanometer-sized, misoriented grains generates molecular-sized pores in the lattice. The density of pores is comparable to that obtained by the state-of-the-art postsynthetic etching (1012 cm−2) and is up to two orders of magnitude higher than that of molecular-sieving intrinsic vacancy defects in single-layer graphene (SLG) prepared by chemical vapor deposition. The porous nanocrystalline graphene (PNG) films are synthesized by precipitation of C dissolved in the Ni matrix where the C concentration is regulated by controlled pyrolysis of precursors (polymers and/or sugar). The PNG film is made of few-layered graphene except near the grain edge where the grains taper down to a single layer and eventually terminate into vacancy defects at a node where three or more grains meet. This unique nanostructure is highly attractive for the membranes because the layered domains improve the mechanical robustness of the film while the atom-thick molecular-sized apertures allow the realization of large gas transport. The combination of gas permeance and gas pair selectivity is comparable to that from the nanoporous SLG membranes prepared by state-of-the-art postsynthetic lattice etching. Overall, the method reported here improves the scale-up potential of graphene membranes by cutting down the processing steps. Significance The energy efficiency of gas separation is expected to benefit from the development of membranes yielding selective but large permeance. The ultimate limit of this is two-dimensional films hosting a high density of molecular-selective apertures (e.g., nanoporous single-layer graphene). Currently, pores are incorporated in single-layer graphene by postsynthetic etching route, and the direct bottom-up synthesis of nanoporous graphene, especially targeting a high pore density, remains a grand challenge attributing to a number of crystallization bottlenecks. We address this by increasing the density of molecular-sized intrinsic vacancy defects in graphene by developing crystallization conditions which promote the growth of misoriented grains, limiting the grains to a few nanometers in size and preventing a complete grain intergrowth while yielding mechanically robust films.
M 1 [Co(CN) 6 ] 2/3 -type Prussian blue analogues (M 1 –Co PBAs) were studied as catalysts for the synthesis of propargylamines via A 3 coupling of phenylacetylene, benzaldehyde and piperidine.