The performance of adhesive-bonded joints, which are being increasingly used in the aerospace and automotive industries, under hot-humid conditions remains largely unknown. The effect of surface treatments on the strength durability of aluminum-lithium (Al-Li) alloy adhesive-bonded joints under hot-humid exposure was investigated. Varied surface characteristics were achieved by different mechanical and chemical treatments; combined mechanical and phosphoric acid anodization (PAA) treatments were also used. The adhesive-bonded joints were then exposed to a hot-humid environment. The surface morphology, strength degradation, failure modes, and corrosion resistance of the substrates were analyzed. The results indicated that the combined PAA/mechanical method improved the joint durability under hot-humid exposure. The treated surface, with a roughness of 2.85 μm, exhibited the best durability, losing only 6% of strength after exposure; the failure mode remained cohesive-failure dominant. The durability enhancement was attributed to the porous and moderate rough surface characteristics, which protected the substrate from corrosion and decreased the rate of moisture diffusion from the bonding interface, thereby reducing the degradation of the bonding interface and improving the durability of the joint.
15 May 2019 in Journal of Adhesion Science and Technology
Herein we investigated the effect of various surface treatments, especially the combined surface treatment of grit-blasting and phosphoric acid anodization (PAA), on the surface characteristics and the adhesion performance of aluminium-lithium alloy sheets. For the combined surface treatment, rough surfaces were firstly created by grit-blasting to increase the surface area available for anodization. Next, porous structures were produced on the grit-blasted surfaces by PAA. The surface characteristics, surface wettability, fracture morphology, and shear strengths of samples subjected to different surface treatments were compared and analyzed. The effect of surface roughness on the bonding strength of aluminium-lithium alloys subjected to combined treatments was also investigated. The experimental results showed that combined treatment provided the best wettability and single-lap joint performances, with the highest surface free energy of 81.4 mJ/m2 and shear strength of 40.8 MPa.