Jiaoyi HOU

Jiaoyi HOU


Research Focus & Metrics

Academic Career Length

15Years (2012-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
18 November 2012 in Journal of Central South University
Verified
Journal Article
Closed access
PDF file
HZHua Zhou
Hua Zhou
JHJiaoyi HOU
Jiaoyi HOU
YZYong-Gang Zhao
Yong-Gang Zhao
YCYing-Long Chen
Ying-Long Chen

21 February 2020 in IEEE Access
Verified
Journal Article
Open access
DNdayong ning
dayong ning
SHSun Hongyu
Sun Hongyu
XAXu Aoyu
Xu Aoyu
GYGong Yongjun
Gong Yongjun
DHDu Hongwei
Du Hongwei
JHJiaoyi HOU
Jiaoyi HOU
Acoustic signal contains information on the state of mechanical motion, but the disadvantage of low signal-to-noise ratio (SNR) is that acoustic signal without noise reduction is difficult to apply to fault diagnosis directly. This study proposes an adaptive noise reduction method based on the dislocation superposition method (DSM), which can realize automatic noise reduction for acoustic signals of low SNR synchronous hydraulic motors. First, the theoretical rotation period of the synchronous hydraulic motor is obtained according to the flow meter. Then, the actual signal is subjected to DSM processing according to the measurement accuracy of the flow meter and the theoretical rotation period to adjust the exact superposition length and the initial position of the actual signal. Finally, when the stop condition is not satisfied, the number of superposition is increased and the above process is repeated. The superimposed signal satisfying the stop condition is taken as the noise reduction signal. According to experimental results, the proposed method has good noise reduction effect on the acoustic signals of the synchronous hydraulic motor health state, wear out state of gear and end cover, and rust state of the gear. The noise reduction signal has been verified to have higher accuracy than the actual signal. Therefore, the proposed automatic noise reduction method can be applied to the noise reduction processing of other kinds of rotating mechanical acoustic signals.

4 March 2025 in Applied Sciences
Verified
Journal Article
Open access
PDF file
YYYong Yang
Yong Yang
TGTingyu Geng
Tingyu Geng
ZZZhang Zengmeng
Zhang Zengmeng
JHJiaoyi HOU
Jiaoyi HOU
DNdayong ning
dayong ning
YGYongjun Gong
Yongjun Gong
To improve the practicability of electro-mechanical converters in hydraulic systems, especially in control valves, a hydraulic force/displacement amplification mechanism was addressed. The amplification mechanism includes a rolling diaphragm (RD) and a corrugated diaphragm (CD), and the amplification function is achieved using the area difference between the RD and the CD. To investigate the amplification characteristics of the mechanism, the diaphragm forces were analyzed by finite element simulations, and the dynamic model of the system was established in Simulink, based on the force balance method. Furthermore, an amplification mechanism prototype was fabricated, and the static and dynamic experiments were carried out. Combining the simulation and experiment results, the accuracy of the proposed dynamic model was verified, and the amplification characteristics of the amplification mechanism were analyzed. When the RD displacement is less than 2 mm, the force amplification effect is not obvious. When the RD displacement exceeds 2 mm, the force amplification ratio (FAR) increases with the RD displacement and decreases with the CD displacement. The maximum FAR is 2.5 with a CD displacement of 0 and an RD displacement of 6 mm. The amplification mechanism and the used research method are helpful for the application and control of the hydraulic valves.