The ability of several oenological fining agents to remove ochratoxin A (OTA) from red wine was studied. The adsorbents tested were activated sodium bentonite, egg albumin, allergen-free adsorbents (complex PVPP, plant protein and amorphous silica (complex) and high molecular weight gelatine), and the non-toxic biodegradable polymers (chitin and chitosan). Several dosages within the oenological use range were tested and the wine pH, colour parameters and polyphenol concentration impact associated with each fining agent were studied. Generally, OTA removal achieved in all treatments was higher when the adsorbent dosage increased, but the impact on wine quality also was higher. Chitin at 50 g hl⁻¹ removed 18% the OTA without affecting significantly the wine-quality parameters. At the highest dosage tested the gelatine and complex treatments achieved greater OTA removal (up to 39–40%) compared with bentonite, egg albumin and chitin. Moreover, the gelatine and the complex had a lower impact on colour parameters and polyphenol concentration compared with chitosan, whilst OTA was reduced to around 40%. Chitosan achieved the greatest OTA removal (67%), but it strongly affected the wine-quality parameters. Otherwise, bentonite showed a relative efficiency to remove OTA, but the CI value decreased considerably. The egg albumin treatment only removed OTA up to 16% and moreover affected strongly the CI value and CIELab parameters. The results of this survey showed that the non-toxic chitin adsorbent and the allergen-free adsorbents tested could be considered as alternative fining agents to reduce OTA in red wine.

In this study, sugarcane molasses (SCM) was pre-treated in a low-cost fermentation medium to produce probiotic biomass of Lactobacillus paracasei ssp. paracasei F19 (LPPF19) with the combination of dilution, centrifugation, and acid hydrolysis (5 molar sulfuric acid, 60 °C/2 h). Microtox analysis, inductively coupled mass spectrometry (ICP-MS), and high-performance liquid chromatography (HPLC) were used to measure the effects of SCM pretreatment on the fermentation process. The results showed that the hydrolysis of sucrose into glucose and fructose was 98%, which represented an increase of 44.4% in the initial glucose content (fermentation-limiting sugar), and harmful heavy metals, such as arsenic, cadmium, and lead, were reduced by 50.3, 60.0, and 64.3%, respectively. After pretreatment, with the supplementation of only yeast extract and salts (Na, K, Mg, and Mn), a biomass of 9.58 log CFU/mL was achieved, approximately ten times higher than that for the control medium used (MRS/DeMan, Rogosa, and Sharpe). The cost reduction achieved compared to this commercial medium was 68.7% in the laboratory and 78.9% on an industrial scale. This work demonstrated that SCM could be used in a cheaper and more effective alternative fermentation to produce LPPF19.