Nan Hu

Dr. Nan Hu


Research Focus & Metrics

Academic Career Length

8Years (2019-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications
29 February 2020 in Journal of Materials Science
Verified
Journal Article
Closed access
PDF file
QZQingqing Zhu
Qingqing Zhu
YLYuan Lu
Yuan Lu
XXXiaochang Xu
Xiaochang Xu
NHNan Hu
Nan Hu

1 November 2019 in Metals
Verified
Journal Article
Open access
PDF file
YCYing Chen
Ying Chen
YTYuanchen Tang
Yuanchen Tang
HZHouan Zhang
Houan Zhang
NHNan Hu
Nan Hu
Nong GaoNong Gao
Nong Gao
MSMarco J. Starink
Marco J. Starink
High-pressure torsion (HPT) is a high efficiency processing method for fabricating bulk ultrafine-grained metallic materials. This work investigates microstructures and evaluates the corresponding strengthening components in the center of HPT disks, where effective shear strains are very low. An Al-4.63Cu-1.51Mg (wt. %) alloy was processed by HPT for 5 rotations. Non-equilibrium grain and sub-grain boundaries were observed using scanning transmission electron microscopy in the center area of HPT disks. Solute co-cluster segregation at grain boundaries was found by energy dispersive spectrometry. Quantitative analysis of X-ray diffraction patterns showed that the average microstrain, crystalline size, and dislocation density were (1.32 ± 0.07) × 10−3, 61.9 ± 1.4 nm, and (2.58 ± 0.07) × 1014 m−2, respectively. The ultra-high average hardness increment was predicted on multiple mechanisms due to ultra-high dislocation densities, grain refinement, and co-cluster–defect complexes.

10 March 2021 in Metals
Verified
Journal Article
Open access
PDF file
ZXZhuoqing Xu
Zhuoqing Xu
NHNan Hu
Nan Hu
YLYuan Lu
Yuan Lu
XXXiaochang Xu
Xiaochang Xu
Biocompatible β-type Ti-45Nb alloy with a low elastic modulus is promising in alleviating the stress shielding effect of Ti-based hard-tissue replacement implants. In this work, the ultra-fine-grained (UFG) microstructures with different grain sizes were prepared by multi-axial compression (MAC) processing of Ti-45Nb alloys, and the mechanical properties and the fretting wear properties of Ti-45Nb alloys in different grain sizes were investigated. The results show that the yield strength and ultimate tensile strength of the sample processed by 27 passes MAC increase by 76% and 91%, respectively, with an elongation of more than 9%. After MAC processing, the friction coefficient and volume wear rate gradually decrease. In addition, before MAC processing, the Ti-45Nb sample shows a wear mechanism of severe adhesive wear, oxidative wear and fatigue delamination; while after MAC processing, the wear mechanism switches to abrasive wear and slight adhesive wear with slight oxidative wear, indicating that grain refinement helps to improve the anti-fretting properties of Ti-45Nb alloys.