Eighteen reinforced concrete beams, including 16 beams strengthened with CFRP laminate at different levels of preload and 2 control beams, were tested to investigate the influence of preload level on flexural behavior of CFRP-strengthened RC beam. The experimental parameters include rebar ratios, number of plies of CFRP laminates and preload level at the time of strengthening. Theoretical analysis was also carried out to explain the experimental phenomena and results. The experimental and theoretical results indicated that the preload level has more influence on the stiffness and deflection of the strengthened beam, both at post-cracking and post-yielding stage, than that on the yielding and ultimate flexural strength of the strengthened beam. The main failure mode of CFRP-strengthened beam is the intermediate crack-induced debonding of CFRP laminates, provided that the development length of CFRP laminates and shear capacity of the beam are sufficient.
Debonding failure is the main failure mode in flexurally strengthened reinforced concrete beams by externally bonded or near surface mounted fibre reinforced polymer (FRP) composites. It is believed that FRP debonding will be initiated if the shear stress on the concrete-FRP interface reaches the tensile strength of concrete. However, it was found through experimental and analytical studies that the debonding mechanism of FRP composites has the potential of shear failure in combination with debonding failure. Moreover, the shear failure probably influences the debonding failure. Presently, there are very little experimental and analytical studies to investigate the influence of shear resistance of reinforced concrete (RC) beam on FRP debonding failure. The current study investigates and analyzes the effect of shear resistance on FRP debonding failure based on test results. The analytical results show that the shear resistance of RC beam has a great effect on flexural debonding load-carrying capacity of FRP-strengthened RC beam. The influence of shear resistance on flexural debonding load-carrying capacity must be fully considered in flexural strengthening design of RC beams.
31 July 2015 in The Open Civil Engineering Journal
Most of the laboratory tests investigated the flexural performance of un-preloaded or undamaged RC beams strengthened with CFRP composites. However, in engineering applications, the structural member must carry a certain load or damage. There is a lack of systematical investigations on the effects of preload or damage level on the flexural load-carrying capacity of CFRP-strengthened RC beams. This paper tested 22 RC beams to investigate the influence of preload level on flexural load-carrying capacity of CFRP-strengthened RC beams. The test variables are preload level, amount of CFRP sheets, tension rebar ratio, and concrete strength. The test results show that if the preload level is not more than 80% of the yielding strength of the original beam, the preload or damage level does not influence the flexural load-carrying capacity of CFRP-strengthened RC beams. However, the ultimate flexural load-carrying capacity is significantly poor than that of RC beam strengthened under a preload level not more than 80% of the yielding strength, if the RC beams are strengthened under a preload level more than 90% of the yielding strength.