This work reports on the synthesis of the intrinsically conducting polymer poly(3,4-ethylenedioxythiophene) (PEDOT) doped with several counter-ions, ClO4, PF6 and bis(trifluoromethylsulfonyl)imide (BTFMSI), by electro-polymerization and its thermoelectric properties. We show that, depending on the counter-ion size, the thermoelectric efficiency of PEDOT can be increased up to two orders of magnitude. A further chemical reduction with hydrazine optimizes the power factor (PF). By changing the counter-ions, we were able to increase the electrical conductivity (σ) of PEDOT by a factor of three, while the Seebeck coefficient remains at the same order of magnitude in the three polymers. The best thermoelectric efficiency has been observed in PEDOT:BTFMSI. From the measurement of the Seebeck coefficient and σ, a PF of 147 μW m−1 K−2 has been deduced, while the measured thermal conductivity is κ = 0.19 W m−1 K−1, resulting in a ZT ∼ 0.22 at room temperature, one of the highest values reported in the literature for polymers. The increase in σ with the change of the counter-ion is mainly due to the stretching of the polymer chains. In this work, we provide a chemical route to further improve ZT in polymers and demonstrate a method of synthesis based on the electro-polymerization on gold. After removing the gold layer, a very thin semiconducting polymer film can be isolated.
In this review, we report the state-of-the-art of polymers in thermoelectricity. Classically, a number of inorganic compounds have been considered as the best thermoelectric materials. Since the prediction of the improvement of the figure of merit by means of electronic confinement in 1993, it has been improved by a factor of 3–4. In the mean time, organic materials, in particular intrinsically conducting polymers, had been considered as competitors of classical thermoelectrics, since their figure of merit has been improved several orders of magnitude in the last few years. We review here the evolution of the figure of merit or the power factor during the last years, and the best candidates to compete with inorganic materials. We also outline the best polymers to substitute classical thermoelectric materials and the advantages they present in comparison with inorganic systems.
16 May 2018 in ACS Sustainable Chemistry & Engineering
Wood (cellulose and lignin)-based hydrogels were successfully produced as platforms for drug-release systems. Viscoelastic and cross-linking behaviors of precursor solutions were tuned to produce highly porous hydrogel architectures via freeze-drying. Pore sizes in the range of 100–160 μm were obtained. Varying lignin molecular structure played a key role in tailoring swelling and mechanical performance of these gels with organosolv-type lignin showing optimum properties due to its propensity for intermolecular cross-linking, achieving a compressive modulus around 11 kPa. Paracetamol was selected as a standard drug for release tests and its release rate was improved with the presence of lignin (50% more compared to pure cellulose hydrogels). This was attributed to a reduction in molecular interactions between paracetamol and cellulose. These results highlight the potential for the valorization of lignin as a platform for drug-release systems.