Caleb Holyoke

Caleb Holyoke

orcid

Research Focus & Metrics

Academic Career Length

25Years (2002-Present)

(Calculated once Scilit publication data is synced: current year − year of first publication + 1)

Representative Publications

View All Publications

1 April 2006 in Journal of Structural Geology
Verified
Journal Article
Closed access
CHCaleb Holyoke
Caleb Holyoke
JTJan Tullis
Jan Tullis

1 January 2006 in Geology
Verified
Journal Article
Closed access
CHCaleb Holyoke
Caleb Holyoke
JTJan Tullis
Jan Tullis

20 September 2006 in Journal of Metamorphic Geology
Verified
Journal Article
Open access
PDF file
CHCaleb Holyoke
Caleb Holyoke
JTJ. Tullis
J. Tullis
Metamorphic reactions commonly accompany ductile deformation of crustal rocks. We performed an experimental study to determine: (i) the effect of syn‐deformation reaction on strain weakening and localization, and (ii) the effect of crystal plastic deformation on reaction extent and distribution. Experiments were conducted on a fine‐grained gneiss (58 vol.% quartz, forming the interconnected matrix, 13 vol.% biotite, 28 vol.% plagioclase and 1 vol.% garnet/Fe‐Ti oxides). General shear experiments were performed at 745 and 800 °C, 1.5 GPa, two strain rates, and shear strain (γ) from 0.6 to 5, yielding three suites with initial phase strength contrast between the matrix quartz and weak biotite of 45×, 25× and 10×; hydrostatic experiments were performed on cores and powders at 750 and 800 °C and 1.5–2 GPa for the same times. At these conditions, biotite reacts with plagioclase and quartz to form garnet, K‐feldspar and water (no melt was observed). Greater reaction extent was observed in deformed samples than in equivalent hydrostatic samples, because of the increased surface area and internal strain energy. In all of the deformed samples, reaction contributes to strain weakening, due principally to a switch to grain boundary sliding in the fine‐grained reaction products. The degree to which syn‐deformational reaction causes strain weakening and localization in this polyphase aggregate depends on the phase strength contrast and how it evolves. In samples with low‐phase strength contrast, strain and reaction are homogeneously distributed; however, in samples with high‐phase strength contrast, ductile strain and reaction interact positively to produce a narrow ductile shear zone. Similar concentration of reaction is observed in some natural ductile shear zones.

5 June 2018 in Journal of Geophysical Research: Solid Earth
Verified
Journal Article
Open access
PDF file
JFJun‐Ichi Fukuda
Jun‐Ichi Fukuda
CHCaleb Holyoke
Caleb Holyoke
AKAndreas K. Kronenberg
Andreas K. Kronenberg
Hot‐pressed polycrystalline quartz samples with grain sizes of 1.7–12.0 μm and water contents of 3,500 ppm H/Si were deformed in a solid‐pressure‐medium (Griggs‐type) deformation apparatus at temperatures of 600 to 950°C, confining pressures of 0.9 to 1.5 GPa and strain rates of 10−3.3 to 10−5.9/s. Two different flow regimes are distinguished at low and high temperatures. The stress exponent determined at low temperatures (600–750°C) increased from 2.9 to 5.2 with an activation energy of 129 ± 33 kJ/mol, consistent with previous quartz dislocation creep laws indicating operation of dislocation creep. In contrast, the stress exponent determined at high temperatures (800–950°C) is 1.7 ± 0.2 with an activation energy of 183 ± 25 kJ/mol. A fugacity exponent determined at 800°C was 1.0 ± 0.2. All samples show evidence of basal <a> slip. However, flow strengths at high temperatures also depend on grain size with a small grain size exponent of 0.51 ± 0.13. Mechanical, microstructural, and textural results suggest that deformation occurs by a combination of intracrystalline and grain boundary processes. The flow law determined from the high‐temperature data can be fit by with stress, σ in MPa, grain size, d in μm, in MPa, and Tk in Kelvin. At conditions of the middle crust and tectonic strain rates, deformation depends on grain size where the strength is weaker than for pure dislocation creep even for grain sizes >10 μm.

1 March 2013 in Physics of the Earth and Planetary Interiors
Verified
Journal Article
Closed access
JGJennifer Girard
Jennifer Girard
JCJiuhua Chen
Jiuhua Chen
PRPaul Raterron
Paul Raterron
CHCaleb Holyoke
Caleb Holyoke