Effect of calcium addition on microstructure, hardness value and corrosion behavior of five different Mg-xCa binary alloys (x = 0.7, 1, 2, 3, 4 wt. (%)) was investigated. Notable refinement in microstructure of the alloy occurred with increasing calcium content. In addition, more uniform distribution of Mg2Ca phase was observed in a-Mg matrix resulted in an increase in hardness value. The in-vitro corrosion examination using Kokubo simulated body fluid showed that the addition of calcium shifted the fluid pH value to a higher level similar to those found in pure commercial Mg. The high pH value amplified the formation and growth of bone-like apatite. Higher percentage of Ca resulted in needle-shaped growth of the apatite. Electrochemical measurements in the same solution revealed that increasing Ca content led to higher corrosion rates due to the formation of more cathodic Mg2Ca precipitate in the microstructure. The results therefore suggested that Mg-0.7Ca with the minimum amount of Mg2Ca is a good candidate for bio-implant applications
This study investigates the cutting forces induced during high-speed end milling of titanium alloy (Ti–6Al-4V ELI) as well as the surface quality of the milled surfaces. The high-speed machining was performed using carbide tool of coated and uncoated types at three cutting speeds of 200, 250, and 300 mm/min and two feed rates of 0.03 and 0.06 mm/tooth. Surface integrity was characterized in terms of surface roughness (Ra) and morphology. Cutting speed was found to be inversely proportional to the resultant cutting force at any cutting conditions. Cutting force in the X direction displayed higher sensitivity against cutting conditions. The results showed that feed rate is proportional to cutting force in X and Y directions regardless of tool type. Under the fixed feed rate condition, cutting force decreased at higher cutting speed for both tools. It was also found that uncoated tool induces less cutting force compared to coated one. High-speed end milling using uncoated tool provided better surface finish than using a coated carbide tool, especially at lower cutting conditions. However when coated carbide tool was used, surface roughness improved significantly with the increase in cutting speed. In contrast, almost opposite phenomenon was observed when uncoated tool was used.
11 December 2014 in The International Journal of Advanced Manufacturing Technology