Hydrocarbons in a gas condensate reservoir consist of a wide variety of molecules which will react varyingly with the change of pressure inside the reservoir and wellbore. The presence of heavier ended hydrocarbons such as C5 and above, condensate banking will occur as pressure depletes. Pressure drop below dew point pressure causes condensate buildup which will give a negative impact in the productivity index of a gas condensate reservoir. Gas condensate reservoirs experience liquid drop out when pressure depletion reaches below dew point pressure. This occurrence will eventually cause condensate banking over time of production where condensate builds up in pore spaces of near-wellbore formations. Due to increase in condensate saturation, gas mobility is reduced and causes reduction of recoverable hydrocarbons. Instead of remediating production loss by using unsustainable recovery techniques, sonication is used to assist the natural flow of a gas condensate reservoir. This study aims to evaluate the effects of various ultrasonic amplitudes on condensate removal in a heterogenous glass pack in flowing conditions with varying exposure durations. Experiments were conducted by using n-Decane and a glass pack to represent condensate banking and near-wellbore area. Carbon dioxide was flowed through the pack to represent flowing gas from the reservoir after sonication of 10%, 50% and 100% amplitudes (20 kHz and 20 Watts). Analysis of results shows recovery of up to 17.36% and an areal sweep efficiency increase in 24.33% after sonication of 100% amplitude for 120 min due to reduction in viscosity. It was concluded that sweeping efficiency and reciprocal mobility ratio are increased with sonication of 100% amplitude for 120 min. This indicates that mobility of n-Decane is improved after sonication to allow higher hydrocarbon liquid production. Insights into the aspects of the mechanical wave are expected to contribute to a better understanding of tuning the sonic wave, to deliver remarkable results in a closed solid and fluid system. This form of IOR has not only proved to be an effective method to increase productivity in gas condensate wells, but it is also an environmentally sustainable and cost-effective method.
Summary: Polymer gel system has been identified as having the potential for blocking and diverting water flow. However, the current polymer reported an inability to maintain its mechanical strength, limited penetration depth, and instability in reservoir conditions of high temperature and high pressure. A distinctive bentonite nanomer clay (PGV)/acrylamide (AM)-co-2-acrylamido-2-methyl-1-propanesulfonic acid (AMPS) preformed particle gel with poly(ethylene glycol-b-tetramethylene oxide) (PEGTMO) coating to control the swelling kinetics is formulated. The in-house formulated gel’s ability to block and divert water flow in a porous medium is studied. The formation recipe of the gel was achieved by numerous swelling tests as induced by brine solution under reservoir conditions. Through the swelling tests, the long-term thermal stability of the gel solution was demonstrated. The incorporation of PGV clay particles improves the swelling and mechanical properties of the gel. Premature swelling can be avoided with PEGTMO coating as it slows the swelling rate over a 10-minute period, which gives the advantage of controlling the swelling before reaching the intended site of action during coreflood experiments. The rheological behavior of the hydrogel features rubber-like mechanical behavior with a viscosity value of 1.17 cp, which displayed water-like characteristics. Further, significant permeability reduction of large fractures is demonstrated by the coreflooding experiment with a calculated result of 96.2%. This formulated gel could offer the solution as a blocking agent in void space channels containing reservoirs that leads to a reduction of water cut due to thief zones.